@@serserimayn106 it does say after each shot. Avg 1005fps with the 27g h&n

@@concentradoAire valdada g2 mini 28x

@F4AUST that's what I'm testing. I'm working out the b.c for the speed I'm shooting. I should have explained better in the video but it was rushed. So, i was shooting good 25g h&n but the quality of the slugs lately was getting pretty bad, so i was trying the heavier slugs using the same tune. I shot groups with the 3 different slugs on multiple occasions but the weather hasn't been the best but the .217 27g were always the most consistent. So, picking the .217 27g slugs I validated the bc @0.072 @ (i think) approx 970fps. Then I increased the velocity after testing the standard agt regulator and the huma regulator but had to validate again which is now 0.095. So, I zerod at 50yds, input all the data required into strelok (ballistic app) then shot out to approx 150yds using the dialling values they tell you. Then (example) say i shot at 150yds, they tell me to dial 30clicks but I only needed 24 clicks to hit, i will then go to the ballistic validation and type that it and it gives you a new b.c to use. Then you verify on the targets. I hope that makes sense. I might make a video just to show

Ill show in a video for you in 1 hour

@pcpkrait6964 the weather hasn't been the best lately and I pretty much rushed this video as there's alot of pests on the farms i need to see too but needed a new slug as the quality of the 25g were pretty bad. I'm at the farms everyday. If there's little wind at some point and I can do it for you I will 👍

@robertthao3865 no, you don't have to. It's good to for the longer shots, to make sure you've dialled back fully. I've done it testing the bc on slugs, shooting at 150yds then fulling the gun up dialling back to 50yds (zero) and completely missing because I'm a full rotation out lol. Alot of the shots I take now I rarely go over 14 moa, so it's just range and click forward/backwards to the number. If that makes sense?

@honda16001 thanks I get it now. Good shooting tho!!

@alejandroortiz7154 you have the depinger but to be honest the tuang noise mainly comes from the hammer/hammerspring. I'm sure the newer model v3s come with a depinger and for the older models you can purchase a depinger and fit it yourself.

@@Mike_Njs I found it best with insulation tape wrapped to the correct thickness in multiple spaced out places along the liner.

@@Yaserroshangar valdada g2 mini 28x

@@AaronBell-vx4pl I do when I remember to turn it on

@@honda16001 Yep, that makes sense. Have you tried the scope on anything besides an air rifle? I was looking for a review on the scope, but can't find any reviews on centerfire rifles...they're all on air rifles. I'm curious about performance of the scope beyond 100 yards.

@AaronBell-vx4pl I've shot passed 250yds all dialling in shots. I've had the scope for a long time now and shoot quite a bit and the tracking is spot on, the clarity of the scope without the go pro connected is so clear and sharp. I've had and looked through alot of really really good scopes and this has hit the mark for me. What do you want to know?

@@honda16001 seems like you covered it pretty well. Thank you.

@@honda16001 actually, one more question...was it worth the price to you?

@@pcpkrait6964 cz barrel

@pcpkrait6964 I'm testing a few slugs out now, I'll see if I can get to 150 👌

1025

@Hutchy46 it's supposed to be 1, 2 shoot but I always shoot first 🤦 But then my mate says he waits to hear me shoot before shooting anyway

Make me laugh, good vid 👍

@@HuntersTrail valdada g2 mini 28x

@ I have the Helix 1500, but it doesn’t work with scopes other than Element because the Element Ballistic app doesn’t have reticles for other scopes. Could you please guide me on how to use it with other scopes?

@HuntersTrail input all the data the app asks for correctly including the "units" part in the bottom left corner. When you zero make sure it's accurate, aswell as everything else. Set your turret to "0", range, click what it tells you, hold dead on and shoot 👌👌 If I'm misunderstanding you and you mean you can't get the ballistic data after ranging. Hold down one of the buttons can't remember which until it changes the the ballistic mode. Is that what you mean?

@Z-he9nv www.bestfittings.co.uk/shop/fill-probes-adaptors/buddy-bottles-valves/buddy-bottle-protective-sleeve/

I did reply to your other comment 👌

@Z-he9nv www.bestfittings.co.uk/shop/fill-probes-adaptors/buddy-bottles-valves/buddy-bottle-protective-sleeve/

Element helix 1500

@Z-he9nv donny ronin. Every rifle I've had, I put the ronin on and the groups tighten up. My impacts and vulcan 3s were the same.

@pcpkrait6964 whatever your rifle prefers bud. Each barrel, plus setup will be different. Hope that helps

@carllarkylark it's a valdada g2 mini 28x scope Yes just input the correct data and then just range and dial in what it tells you, using the clicks on your scope.

@@Hutchy46👌 all from the feedback 🤣🤣

😂 Good lad, massive improvement 👍

@@pcpkrait6964 avg 1015fps

I ve got to shoot the distance where the birds land. 👌

@honda16001 Need video of H&N hp2 25 gr slugs, knockout mk2, or knockout slugs 25.39 gr 970-1010 fps 150 yards grouping. Why is no one showing such a video? I want vulcan 3 .22 caliber buy.

@pcpkrait6964 that wouldn't be a fair test. If you set the rifle at say 1000fps 1 of the 3 slugs you said might love that velocity and the others might be a shotgun grouping. Plus every gun/barrel is different, say if I did the test and then you bought the v3 because of that test and it wasn't the same results with your new v3, you'll be doubting the v3. Hope that makes sense. The v3 is an awesome rifle though and everyone I've tested (after polishing the barrel etc) likes .217 25g hp2 slugs

@@honda16001 I want to buy vulcan 3.22 caliber. Used Airgus 60, krait x, Epic two 700mm barrel, jkhan noblesse. Now for the last time I will use the vulcan 3 700mm .22 cal.

@@pcpkrait6964 avg 1015fps

Ang 1015fps 👌

Avg 1015fps👌

@@honda16001 nice

Cheers 👌

@@HurshedRaupov the vulcan 3 for me

@@honda16001 Thank you very much brother

@jonathanmcghee9541 it's not my prophet the v3 is mine but I think it was set to around 160bar

@Hutchy46 the last video posted, I played the video clip in normal speed then clipped it, were I just played the shot in slow mo. What did you think of that?

@@honda16001 yeah good one i much prefer that 👍

@tonysalazar4068 There's so many new air rifles coming out now. For me, Vulcan 3 Fx impact You can't go wrong the rti mora Epic 2 Fx panthera/king Are the ones I want to try

@@Anfänger123 amzn.eu/alaUPxg

@@youtube_threeBairguns cheers. Cz

@JohnVentarino-ey5ln this isn't the only farm I shoot crows on. Some farms worse than others. It's bad for wood pigeon aswell but the fields aren't flat, so you either can't get an accurate range or when you see them fly in they disappear because of the dips lol. It's because of the livestock and crop damage. The amount some of the farmers lose is wrong, no eyes, no tongues. I'm not just talking about young/newborn livestock either.

@@surreallife777 cheers, much appreciated 👌👌

@@honda16001 In terms of the AGT and KalibrGun brand or any other brand in terms of shot count, FPS and FPE are there any other manufacturers that come close to the FX impact, crown or King?

@@surreallife777 Karma airguns red panda Agt vulcan 3 Rti mora The airgun world is definitely moving forward quickly now.

@@kallemlink avg 1015fps 👌

@@honda16001 cheers 👍

😂😂 no that's checking my zero 😂 the videos aren't in order

@nicksamsunggalaxys2404 I was going to include it in the next video as that's the zulus but I'll give it to you here instead: Twist rate 17.7 left Zero distance 33yd Scope height 2.91 G1 .217 25g Bc 0.100 1015fps

@@honda16001 much appreciated I was struggling so much

@@honda16001 still do the vid i bet people are struggling other vids leave a few sections out ie twist and drag

@@nicksamsunggalaxys2404 I'll upload a video today of the arken 👌

@deanpike8376 yes wales 👍👌