Thanks mate. Yeah it's been a lot of work. Good luck to you. The front end is from Curley's in Melbourne and we went with a GM stud pattern.

@ProShop1 thanks mate ill have a look into that.

There is a small gap at the front of each baffles that should prevent air locks Thanks for mentioning it as I didn't.

The outlet was roughly the same size as the tap so with a little thread tape I just screwed it in the hole.

Thanks Peter. Good idea

Thanks mate. I started out as a mechanic then learnt bodybuilding while building limousines.

I've spent many many hours on a panbrake folder when building limos

@@ProShop1 today I welded up the love bar holes 🕳️ and Torno cover pinholes in my quarter panel one ☝️ side on my 96 xh falcon ute I worked out how to remove the inner support brace panel it had one spot weld in the middle of the three holes for the XD plastic Torno things and I gently removed it from inside the quarter with a panel hammer and sharp paint scraper to separate the glue between the holes anyway I used a one KG copper block held behind the holes and slowly mig welding them up and cooling each weld with air as I filled in the holes I was surprised I got no buckle minimal I worked out because the love bar holes were stretched from people tying rope on em I shaped around them or shrink them on the round side of a toe dolly by hitting in the middle with dolly pushing out on the lows and tapping highs in we’re the bolts we’re holding the bar on like a massage and not stretching the metal with the hammer by hitting the dolly on the high if you know what I mean was fun 🤩 on the old falcon

Easier way of saying it was I tapped the highs into the lows with a toe dolly slight round face hammer . middle of the love bar holes were stretched and around the hole were the washer on the bar was low on top and bottom of the holes from bar being used for a tie off and people leaning on them in a downward direction

That's amazing. I always look forward to your stories Michael. Thanks for sharing

Yeah I've been doing it the hard way for years until I found out that little hack

The round one is from Plazmaman and the oval one is from Bend Brothers.

Thanks mate. Yeah I did have it under the diff however there wasn’t enough clearance if I needed to drop the diff and take a wheel off.

Will do David. Thanks

Glad you enjoyed it Bill

Thanks a lot Anthony

Cheers. Will do. I enjoy making them

Much appreciated!

Cheers Sam

Thanks again!

Glad you like it William

Cheers🙏

Thanks again Paul

Always great to hear from you Michael. Congrats on the baby. Yeah looking back I probably should of worn more protection when welding too.

Cheers Steve

Found a Thru Hull Fitting, looks like it should work.

Thanks. Yeah that would be good. Where are you located?

Thanks! Will do!

I'm not sure. The customer brought me all the parts and I just put it together.

Cheers Tony. Great to have a fan from Brazil.

@@ProShop1 j love a american old Cars and your Job man,👍👋

Thanks mate. Glad you enjoy it

Thanks Glenn. Good to know I’m not the only one 😆

I'm only one man so it's quite long😃

Cheers Pauly

Thanks Jason

Thanks for coming down Ritzy. Your welcome anytime.

@@ProShop1 legend 👍🏻

Will do Kieran👍