Tnk

LoL it's been a while since this was made but a friend of mine does make the collars so you can use other dops in the raytech

you can also use an agate burnisher, (much cheaper than a Norbide stick) which is fine, because it is still quite a bit harder than copper and will still burnish the copper..

sorry to finish using a copper dist or what?

Precio de ese brazo facetador ...gracias

been faceting for 54 yrs. on all type machines. a simple long enough collar can be used to adapt to 1/4" dops. i make these for my 5 raytech's . [email protected]. new machine is $1950 and laps cheap from china.

Is your fingerprint present till this day?

Aren't the dops held tight after tightening the nut on back od dop? Doesn't that secure the dop without movement? I understand it doesn't solve your other dop problem but the dop shouldn't move after tightening nut. I ask because I'm considering this machine.

hello good morning companion Interesting like Guaranteed Fuiiii

Do you use this bearing for other grit diamond, or do you dedicated just for 5his grit?

Can I use the bearing to charge another lap with 3000 or do I need to use a new bearing?

anyone stumbling on this video, his demonstration is wrong. This gentleman's video is a much better tutorial: kzbin.info/www/bejne/hYGqnH-qnLF2qNU Burnishing should be done before the diamond is added. The whole point of burnishing is to work harden the copper surface so the diamond does not embed itself all the way into the soft copper. The diamond need to be stuck in the copper but sticking out enough to cut your work without leaving copper streaks in that work.

Hola desde Argentina muy buen video no te entiendo pero me gusta

I am a newbie.

What is the advantage of using copper lap instead of any other kind?

dear Sir We manufacturing All type Diamond Disk 1500, 1200,1200-, 900, 600f, 600ff 600m 600r 360,260 all type

Just a suggestion but you can add an extension to the dops . little hobby lathe face off the dops drill and tap. Add an extension with the same threads as the raytech on the back. You make them the same length.

When you use the lap for polishing, do you lubricate with water? Oil?

how to r p m ti moter

sir plz my halp for GOD

.how to use copper lap for bre-polishing and fainal polishing? and which polish powder use for best what is the type of disk ...thank you

It sounds like you have both, an Ultra-tech faceter and the Raytech Shaw. Which one is better and easier to use?

sir what is the type of disk ...thank you

thanks...how to use copper lap for bre-polishing and fainal polishing? and which polish powder use for best ?

Thank you!

hello. where i can buy a raytech as yours...and how much it in $ ?

Where are the wholesalers? I have been searching over and over and over again.

Thanks for going into the details as you did. Question: I noticed you changed the speed a few times. Being a spinning circle the actual speed is low towards the center and increases towards the edge I would think you could use a higher rpm when your pressing in the central zone then lower your rpm's as you work towards the edge. I guess the question is just how much speed matters, maybe not that much? If a faceting machine were like a belt sander then it would all be the same.

Hey great setup. Dont know if you have done your mod to raytech yet, I know im 2 year late, but the way I would do is to either have one made at a machine shop out of aluminum or buy heavy duty thick walled aluminum tubing with the same diameter as the collet drill two holes one to lock the new collet in place and one to lock the dop to it. You drill the holes the same size as the screw then you have to tap them with a tap and die set. and there you go. good luck.