Have you any idea if the self-propelled feature can be shut off?

The wiper arm on my Tahoe is really frozen. Tried a couple of shots with WD-40. Afraid to put too much torque on the bolt since the motor is also rotating some when applying the pliers. Suggestion? Thanks!

Thanks mate.

i get the motor running... but cant get anything to spray... any thoughts? hart 4 gallon

Good video. But I Would NEVER Work on any piece of equipment without a thorough cleaning. It was hard to watch as you dug around all of the garbage trash, dirt, etc., to get to these parts.

There is a better system on Amazon that does not need any power supply. I put that on my 2019 forester works great.

I followed the instructions despite being concerned about tipping on side.. I turned off the fuel and still filled my carburetor with oil. Shop nearby now has to clean out the carb as i don't have time/will to do that. Should have followed my instincts and just raised the back wheel a bit.. now it's in the shop for 3 weeks and will be expensive. My shop doesn't recommend this method even with the shut off gas valve

The wheels wear out really fast. If you don't top it off with fuel, it will run out of gas every mow. (1/4 acer, St. Agustine) Don't miss too many cuts, it can't keep up with how fast the grass grows. The governer shaft WILL leak after 3 years. There is a seal that you can get from Honda marine division to install to fix it. Cost $6.30 USD. Not sure why the didn't come installed from the factory, easy fix.The front wheels splay out after a while, but you see it more than you can feel it. Re-treading the drive wheels with mountain bike tread and screws gives more grip and power. Good, easy, reliable mower will keep it, but need something bigger after removing trees and rehabilitating the turf. EDIT: More like 1/8 acre of turf.

Top work!

Crybaby in this chat😅

Thank you for the review, I too am wondering what the better/cheaper options are. Thank you.

The plastic parts like the handle locks and mower speed controls deteriorated in a few years on my mower. Also the propulsion belt slips if there is ANY moisture in the lawn. The carburetor control springs rusted away quickly and have been replace with genuine parts frequently.

vice and a hand-held file is the way to go imo, maintains an angle much better and removes less material.

You don't maintain your lawn mower very well do you. The undercarriage is full of dried stuck on grass. The owners manual says to wash the mower regularly and keep it CLEAN.

i have the 2gallon harts sprayer and it works great, just for your info i sprayed 1min into a measuring cup and got 18 oz 128 which is 1 gallon, divide 128 by 18 = 7.11111 x by 15 -106.5 sec which is 1min seven sec per 1000 sqft i hope you this wil help you calibrate your sprayer

Thanks for the review! What are those cheaper better options you are talking about?

dude thank you...u saved me.... much appreciated

My worked for about 2 minutes and will not pump pump runs and no pressure

Thanks so much. Yes, this is a $50K vehicle than regular RAV4 and no ideas what Toyota was thinking not correcting the design for years just having one and two bump dots on the switch surface... for visual impaired drivers, maybe😮

is this a stainless deck ?

Blah blah blah ,way to dast , how about a brownie receipt or just keep repeating yourself. . Over and over and over

Got a lotta experts in here. Do your own video then. This does fine for my HRN216.

Thanks for sharing your experience 😊 i need simplicity with mowing hard for me as i get older.

I have the same mower, how often should I change the oil filter? Thank you!

You are a Goat 🐐 man , thank you

Clean mower. Grease rear wheel gears. But nice presentation of transmission changeout

Biggest problem is when you buy a replacement blade in the garden dept. at Walmart it does not fit. Says on the blade fits 20in. 40volt Hart lawnmowers. Well guess what, it does not. My mower is a Hart 20in. 40 volt and the original blade on it is 191/2 inches long and the replacement blade is 20 in. long. It makes sense, but you cannot install it on your Hart mower. I returned it to Walmart. So, measure your blade before you buy.

Where did you order parts from Honda dealer ?

I have a 2018 Honda Mine locks up going forward Locks and stops Could this be transmission… 2020 put a new trans and bushing in under warranty… I agree on tires Three or four sets on this thing … but cuts really good when working Thanks for Video Glenn

Thank you, this was annoying lol

All the safety precautions in place. But you should torque your blades.

Mine won’t fan spray any more just stream

I read this today in the Honda HRX217K6VKA Shop Manual Serial Number MAMA-1000001 - 9999999 " a. Clean and inspect the pinion gears, wheel gears, and ratchet keys. b. Thoroughly apply a coat of Honda Marine extreme pressure NLGI #2 GC-LB grease (or equivalent) to the ratchet key, spring, and axle on the left and right sides. IMPORTANT: Only use an extreme pressure NLGI #2 GC-LB wheel bearing grease. Proper application of the correct grease is critical to ensure proper operation. DO NOT USE anti-seize, white lithium, silicone, WD-40, or any other spray lubricant. c. Be sure the correct pinion gears are installed: 9-inch wheels use 13-tooth pinion gears.

When I worked at a golf course the owner insisted we spray off the grass debris every time we used a mower (every day). He said the grass will eat away at the metal. Ever since then I spray down my mower after each cutting. Only takes a moment.

I juat replaced mine on a 2011 gmc yukon...the arm works,but the fluid doesnt come out...its coming out the front bottom...like it clogged or something...it worked b4 i changed it out any suggestions?

Great job blocking almost the whole inatallation.

What is the snap ring pliers that you use?

No special gapping? Just install it out of the package?

Is hru the same?

Love my hart sprayer👍🏼

Thank you!!!! This has been driving me absolutely crazy for months. I ripped the whole dash apart thinking one of my kids dropped a bead of something under it. Sounded like a marble rolling around from the passenger side. Your fix was exactly it. Screw fell out and the other was loose. Thank you!!

mine had an extra sprayer nozzle. What does it do?

Amazing 🫡

Who does a review and doesn’t actually show the product being used? Waste of everyone’s time.

You saved me a lot of trouble shooting and aggravation, great find thank you!

i need to know what type of nut (size and thread) is behind the wheel cap (hub cap) - one of them fell off of mine. if you know, i beg you PLEASE tell me the name so i can go to the hardware store or to an auto part shop to get it. the Hart people dont seem to know what it is that i need after MONTHS of calls and emails! Thank you!

Nice video of your left elbow. Next time, try moving the camera so we can actually see what you are doing. Oh, and music, don't get me started.

I have a commercial Honda HRC 2163HXA that I got in 2014. I’m wanting to replace the plate set product number 25010 - VD 6-900 in the transmission I am wondering what kind of job that would be to get inside the transmission and replace this part? That’s what cost me about $70 for this part compared to $700 to replace the whole transmission. Just wondering if you have any videos on transmission overhauls, like this one

I forgot which washer go where. This video helped we get it correct thank you!

I also use the 4amp battery which may make a difference also. I think the battery you have there is the older 2amp model battery