You never use that cooper spray on a new head gasket. Stupid if you do. And you use new head bolts

I believe those head bolts need to be replaced since they are Torque-to-Yield bolts. They are designed to stretch when initially torqued and should not be reused once removed. Special Tools EN-45059 Torque Angle Sensor Kit For equivalent regional tools, refer to Special Tools. Clean the sealing surfaces. Inspect for plane surface. Cylinder block, cylinder head Straight-edge, feeler gauge Install the cylinder head gasket. Install the cylinder head. Caution: Refer to Fastener Caution. Caution: Refer to Torque-to-Yield Fastener Caution. Note: Note the correct tightening sequence. Install NEW cylinder head bolts. Tighten the bolts (1) in 5 passes. Use the EN-45059 sensor kit : First pass to 25 Y (18 lb ft) Second pass to 90° Third pass to 90° Fourth pass to 90° Fifth pass to 45°

What was the fix to this?

Much of what you’re doing is not in front of the camera.

Hello

Is there a kit for replacing the head gasket? How much does it cost?