@Lakeman3211 them being low compression is what makes this so much easier. I have already built a modified blow through Marvel Schebler for it. Not worried about fuel consumption, this tractor is too small to do much on my farm anyway. It's pretty much just for fun.

@@Lakeman3211 what is the other related business?

@johndowe7003 no idea yet, it's nowhere near done. I will definitely post updates though! 👍👍

@Houtsy o yes I certainly thought so!

@@jammasterjay 😂😂😂😂

@@destroytheilluminati770 no this was in NJ

@MartinOja-d9k just a small 12v dc one. Check on Amazon, they are usually blue.

@TooManyProjectsTooLittleTime ok but you have 3 wires? S, V, GND right? How u get work signal wire?

@MartinOja-d9k 1 Channel Relay Shield Module, 3PCS DC 5V Indicator Light LED Module for Arduino R3 MEGA 2560 1280 ARM PIC AVR STM32 Raspberry Pi MCU DSP Official Boards Shield (3PCS) a.co/d/9H3V7MR

That's the one I used^ the 3rd wire is the signal from the laser to turn on and off. Make sure you run the laser setting at 100% constant power.

@zanetreeconstruction9470 thank you 😊

@@Islandcitymedia there's many out in the wild!!!

@Db25865 only if you intended to run a ground speed PTO but yes you could certainly do that. Keep in mind the shaft is welded to the pinion so it's meshed with the ring gear. I did play with the idea of doing the rear-most axle as a pass through with a splined PTO shaft coming out the back so I can make a trailer also powered behind it with a quick connect pto shaft like a Gamma Goat.

@Db25865 o yes, there a plenty of ground drive implements out there too! Would definitely be useful. Infact several of my tractors have a ground drive position for the PTO.

@stuwy1237 the shorts I film just with my phone that's why they are like that, my apologies. The regular videos are filmed with an actual camera and a tripod. Actually yesterday I bought an automatic tracking one so the video quality should improve more soon.

@@zakbrinkhoff324 it's coming soon!!

@DELTA912420 well sort of! Basically this is a mini version but it is going to depict a more Americanized version. But yes it is based on the German G4 Staff Command vehicle.

@pauledwards7182 that's what I'm doing 😁😁 sort of

It's for a 6x6 vehicle. This is the first rear axle inline. The pass through shaft is for powering the rear most axle.

@simo8569 thank you! Yesss lots of trial and error.

@cmtfarms9777 thank you!

@@Ciso_diagnostics 😁😁

@@rickyj2013 I'm very well aware of what a power divider is.

@Stank-b8w I haven't decided yet but most likely there won't be a power divider on this one.

@davidt1621 😂😂 no that's down the street behind the truck stop 😂😂

@@jasonhunter2611 😂😂

no but the owner is a friend of his

@coolruehle this has been explained multiple times already in the comments. It was after midnight and I was dead tired and misspoke. I'm sorry I offended you so incredibly much with a word. No need to have an attitude about it.

@johnguilfoyle3073 it was a reference to the fact that he drove it on the highway when it goes like 40mph and we live in a town where the cops are out for blood. If you so much as take your ATV to get the mail everyone calls the cops and goes nuts.