I wish to cut 10mm diameter colored acrylic rods into 50mm lengths in quantity and polish the cut edges. These will be used in jewelry production so a finished look is necessary. A slight bevel would be nice. These could be chucked on a drill press then spun against an abrasive or buffing surface. For instance a sanding/buffing block fixed at an appropriate angle. Some guidance would be greatly appreciated.
@marketingbermaq87303 жыл бұрын
Did you know that with a diamond polishing machine you can polish a piece like that in less than a minute and with excellent results? In fact, with the BOX mini edge polisher, you can achieve high-quality results as if you were using a CNC machine: kzbin.info/www/bejne/aIjLYaWAlseFhdk
@peterbuller35723 жыл бұрын
What oven temperature do you need to form polycarbonate?
@reddeadtwats82524 жыл бұрын
Lol hai yen pham sounds like hi yen fam also I have to watch this for class
@dingleberryfromatree11095 жыл бұрын
yo shout me out my diggity dog
@jayjohnson86565 жыл бұрын
Very helpful! Your instructions are clear and easy to follow.
@sabrcaptainprice85906 жыл бұрын
Thank you so much 😊 it helped me understand
@ratfan576 жыл бұрын
how hard is it to say LINE!
@classcomp8 жыл бұрын
How much is the cost?
@mxkesh54958 жыл бұрын
Safe g 😂😂😂
@jeremiahwalker41358 жыл бұрын
you actually need to file only in one direction with a single cut file. Do not drag the file back across the filed surface. the file you are using only cuts on the push stroke, not pull.
@poomunj10 жыл бұрын
some huge problems here
@DELABR010 жыл бұрын
this is awful. your lines arent straight because youre drawing with your wrist and not your whole arm.