the trick is to set "Slice gap closing radius" in advanced settings really low, like 0.001 this would address the issue @noplacetogo800 mentioned. (many examples you showed in the video did actually not work because of this, like the diagonal seam) overall a very educational video with lots of great ideas, though the audio quality could be improved
Looks nice and usable 😃 Will use it in my next project where I need many states and transitions.
@mlab30512 ай бұрын
Feel free to contact me anytime if you have some difficuty or suggestion. You can message me in FB page facebook.com/MLabpage
@noplacetogo80011 ай бұрын
When you cut only with 0.01 width, the slicer merge the perimeters and finally the are two clasic perimeters despite vase mode. You can see that when you switch on seams in view. Real vase mode is seamless. You need at least 0.1 mm gap to have desired result.
@mlab30512 ай бұрын
That pretty good intel. I will keep that in mind and look at this factor nextime I print in vase mode.