Can we slso take alginate impression to make provisional bridge
@franklintruax583011 ай бұрын
where can I get the magnet strips used in this video?
@fzdd-k6g Жыл бұрын
Thank you so much for the video. Please keep uploading more content. You are an excellent Teacher!!
@ElCachalo Жыл бұрын
Please, could you tell me the model of the Asus laptop that is shown at the beginning of the video?
@Charif301 Жыл бұрын
❤❤❤
@Charif301 Жыл бұрын
❤❤❤❤
@anuarde Жыл бұрын
hablas español ? sigue siendo buena inversion el nevo e4d scan en la actualidad?
@johnnigro57912 жыл бұрын
does the scanner scan the arch to real color on the screen or is it always set to stone look
@danielmontero19802 жыл бұрын
Newer scanners will scan real colors, which you will see them on the digital model. You can also choose to see it as a stone color. In this particular video, the scan was made with an "older" scanner that does not capture colors.
@hernandesvalverde3 жыл бұрын
Are you costarican
@gulnar315 жыл бұрын
Thats really useful Thank you so much
@Bohongihatikuu5 жыл бұрын
Dr. Daniel, when taking the impression should the cords be left in sulcus or removed then quickly dispense the impression material around the finishing line so it flows into the sulcus?
@danielmontero19802 жыл бұрын
I like to remove the cord with the long tail (second cord for the 2 cord tech/ the only cord for the single cord tech). Basically you are filling up with impression material the space where the cord used to be. Soft tissues can change form and collapse very fast so the faster you inject the impression material after pulling the cord, the better. Make sure you have the site clean and dry before starting the procedure. Hope this helps!
@diegojosegonzalez5 жыл бұрын
Thank you so much
@watercolorflower5 жыл бұрын
Hola Doctor! Puede subir otro video explicando como hacer los ajustes oclusales?
@mg-of4mm6 жыл бұрын
But , you did a very good job 👍🏻
@mg-of4mm6 жыл бұрын
Tu haces un provisional así y ten por seguro que el px no regresará 🙄🙄
@officialslikmixx87197 жыл бұрын
Hello can you tell me we're I can get the fabrication kit