No if you use only outlet of RO then it can be used but in this case final water is blended with filter water in ratio.

Go for regeneration

Sir please

Purpose is same but arrangements is different in Lamella FRP PLATE IS USED and I tube settler tube shape arrangement I. E hexagonal I. E honeycomb type assembly is there.

Sacyasba me

In both SAC and SBAif conductivity increases means resin is getting exhaust.

Not required actually we have to prevent pump from back pressure of pipe line therefore we have to must put NRV in discharge line.

If you put NRV in suction it prevents free flow to suction of pump so pump will not get sufficient inlet so cavitation occurs and insufficient flow.

Thank sir

Thanks for your views please support my channel .

Good question Degasser is installed after SAC ok.So the output of SAC free from cation and it is replaced with H ok .I think this is sufficient to make you understand for more clarity watch my video of SAC. If any doubt you can ask me again.

Thanks for your comment dost I will improve please support my channel.

Carbon dioxide removed to acceptable limits i.e. 5 ppm

Thanks for your comment I will improve ,try to support my channel.

Down flow means water flows from top to bottom and upflow i.e reverse of above.

@@watergyan8933 that means water enter from top & exit from bottom , will called down flow, is it right sir.?

May i get your contact number sir.?

May i get your contact number sir.?

@@MDDANISH-gl3rg water enters from top and comes out from middle collector outlet . If you have any doubt watch SAC,SBA video of this channel .

I think MB k outlet mai 1 ms se niche rehna chahiye E/C

All steps done during regeneration. Backwash - during this water flows from bottom to top therefore named as backwash. This steps done to loosen the compacted bed and removes the suspended particle from bed. Middle collector flushing : this step done to clear the top layer of bed near middle collector header so that during regeneration regenerant and downflow water comes out properly . Inactive resin named because this part of resin never regenerated its use only to keep the bed in compact for therefore inactive resin placed at top of bed through which middle collector header completely inside. Slow rinse: this step done through the same path which was used during injection . This step continuously push the regenerant for conversion and to remove the regenerant from the system. Final rinse or fast rinse: this done by following the service cycle i.e. in this service inlet and service outlet valve used and water flows at service flowrate and this step used to remove excess regenerant from the system ,this is the last step of regeneration.

@@watergyan8933 Thank you sir,❤️

You can watch SAC AND SBA Video for your answer

Ro me ions remove ho jati hai so pH down and after that degasser me carbonic acid breaks and reduces the load. You can watch degasser video.

Iski height depend Karti hai capacity of plant . So it's varies as per plant capacity.

@@watergyan8933 give example sur