Пікірлер
@matthewbishop8743
@matthewbishop8743 5 ай бұрын
I think the problem is the lack of plants from the beginning. All soils have so many nutrients that you basically have to plant the entire tank to prevent algae growth. And of course, do daily water changes at least for a month.
@jorgen.zamora
@jorgen.zamora 5 ай бұрын
wow.. you could have planted 3 tanks like that one with that soil and some other subtrates/gravel/sand and still have great nutrients and results 😅
@NESig
@NESig Жыл бұрын
Those littlle Hondas are such good little motors.
@Prototheria
@Prototheria Жыл бұрын
If speed is of any concern to you, that's a long shaft on a short shaft boat. You'd either need to raise that engine up 5", convert it to a short shaft (not hard or expensive), or get a short shaft engine. Also, check your RPMs... it's not good to load them up too much and you need to be able to hit a certain RPM at WOT. For the 7.5, it needs to run between 5000-5500 RPM with 5200 being the target. If it's less than 5000 RPM, which it sounds like it is, then you'll need to go with a lower pitch prop or get that engine up higher so the ventilation plate (big flat thing above the prop) is about level with the bottom of the boat. You can use a $12 tiny tach to verify RPM. Hope that helps. She sure is a sweet runner.
@daviddave8266
@daviddave8266 Жыл бұрын
Made it look to easy
@EJE240
@EJE240 2 жыл бұрын
Like silk. Nice, relaxing video
@jbreefer148
@jbreefer148 2 жыл бұрын
I'm looking at getting the 10hp model but the seller said that it is loosing spark. I'm concerned that I wouldn't be able to find quality replacement coils for the ignition system. Amy advice please. Thanks
@boatingmanchester
@boatingmanchester 2 жыл бұрын
I have the same engine and when you talk about the idle screw at 5.05 you mention unscrew one and seven-eighths ? what is one and seven eighthts in inches ? As I dont understand what it means please excuse my ignorance
@LukeLGK
@LukeLGK 2 жыл бұрын
Great video!
@maxipower6932
@maxipower6932 3 жыл бұрын
Very well done vid. So clear and concise how you when through fixing the idling problem on this amazing honda outboard. I bought same one today, the seller got it running but it will not stay on. He suggested new gas with sea foam in it. But now i know what else to do thanks to this video. Thank you, subbed!
@shelbywilson114
@shelbywilson114 3 жыл бұрын
How the even ran with the mix all the way in is crazy
@secondamendment
@secondamendment 3 жыл бұрын
Sorry to hear that :(
@secondamendment
@secondamendment 3 жыл бұрын
Now that some time has passed are you happy with this product still?
@jeffblundo1011
@jeffblundo1011 3 жыл бұрын
I’m not unhappy with it. However my other tank with Fluval Stratum as the substrate has done much better. This tank suffered an algae bloom this Fall and I had to remove all of the plant growth to get rid of it.
@Fooosh2Day
@Fooosh2Day Жыл бұрын
My fluval stratum dissolved it 2 months. Caused lots of problems in my tank resulting in my buying new substrate😭
@jorgen.zamora
@jorgen.zamora 5 ай бұрын
​@@jeffblundo1011 the algae explosion was because this amount of substrate was way too much for that tank. 😬
@vikaskumar3236
@vikaskumar3236 3 жыл бұрын
Thanks.
@nicot2436
@nicot2436 3 жыл бұрын
👍🏻
@heywoodclaxton988
@heywoodclaxton988 4 жыл бұрын
I love the MirroCraft that the Honda’s on I’ve got one, does the 7.5 move it ok?
@KB-ic3th
@KB-ic3th 4 жыл бұрын
Damn...7.5 liters in such a small motor. Impressive! I got ripped off...mine's just 7.5 horse.
@robertjanbout1437
@robertjanbout1437 3 жыл бұрын
Some little tolerances... Mine is 200cc so that's 7.3 liters less.
@EJE240
@EJE240 4 жыл бұрын
Nice work! I wonder if someone thought that was just a loose screw that needed to be tightened. She sounds good.
@EJE240
@EJE240 4 жыл бұрын
I like the binder clip holding the tubing
@jeffblundo1011
@jeffblundo1011 4 жыл бұрын
Thanks, those clips have many uses in my house. Almost never holding papers though.
@EJE240
@EJE240 4 жыл бұрын
Great video! Hope to see Part 2, the engine swap
@jeffblundo1011
@jeffblundo1011 4 жыл бұрын
Thanks Eric! It’s coming soon!