Cadillac XT5 Front Hub Bearing Replacement

Step by step process of replacing a Cadillac XT5 front hub bearing replacement. Due to a complaint from my wife her vehicle sounding like an airplane taking off or landing, and through diagnostics, we found out the wheel bearings needed to be replaced.
Parts
Front Wheel Bearing & Hub Assembly
amzn.to/42NnUlP
Tools
10,000LB Two Post Overhead Auto Hoist
amzn.to/3WNMmSx
1/2-inch Drive Axle Nut Socket, 36mm
amzn.to/3PjcUJj
DEWALT 20V MAX Cordless Impact Wrench Kit
amzn.to/3qOZivH
Brake Caliper Hangers
amzn.to/3pdCHZh
1/2-Inch Drive Click Torque Wrench 25-250 Ft-Lb
amzn.to/3NgaN6J
Anti-Seize Lubricant
amzn.to/46d2hxY
Work Light, 2500LM Bright LED
amzn.to/3JI4fx5
Host, Jerry Jackson
Camera and Editor, Tina Jackson
Music Funkorama by Kevin MacLeod
Link: incompetech.fi....
License: creativecommons...
Be sure to like, subscribe and share.
And remember folks, “If you put your mind to it, you can do anything. See yah.”

[@therealdrod5634]

Thanks for the video buddy, I didn’t think there’d be one on KZbin but thank god you did it! We have the same sound coming from the front end of our 17’ xt5. I think I can knock this out on a Saturday morning. 👍🏽👍🏽👍🏽

[@JerryJacksonDIY]

Glad I could help

[@JHUGHES484]

My 13 XTS has a left front wheel bearing stuck in place. Tried every trick in the book to get it out. I found there is a tool ( hub buster ) you bolt on the wheel studs and pound it in a downward motion and it will force the bearing hub assembly out. Have You ever used one or familiar with them ?

[@JerryJacksonDIY]

No sorry. Not familiar with that tool but sometimes you have to get creative to get the job done.

[@danpeletis6526]

I don't see the tool list

[@tommyfairchild90]

what size socket id the axle nut

[@JerryJacksonDIY]

36 mm

[@sivispacemparabellum7633]

Thank you for making it look so simple 🙌. On to do the same thing on my XT6. One question though: is an alignment advised after work?

[@JerryJacksonDIY]

Thanks for the question space. Since you are not changing anything to do with the geometry of the alignment I did not. Thanks for watching.

[@GaryClark-mz4nm]

Thanks for the help! This video was a huge help and cost saver!

[@JerryJacksonDIY]

Glad it helped. Thanks for the comment and thanks for watching.