104" Skywing Extra NG build part 1. Landing gear, rudder and tail-wheel assembly.

[@manuelcarrera5492]

como se LLAMA LA PIEZA

[@waynerc1841]

What canisters were you waiting on for DLE130 - what size Falcon prop did you settle on - tks Wayne WRCS (busy with my build atm)

[@joeytavora1270]

G'day Wayne, I used JMB and contacted Milan directly. They are perfect for the dle130. I was using a 28/10 for 3d and I now use a 28/12 for my IMAC competition flying. Would love to see your build when it is done.

[@waynerc1841]

@@joeytavora1270 Hi Joey Your videos have been a great help in the assembly on SW NG 104” A couple f items that could be highlighted: I assumed the elevator servos were mounted in the elevator sub assemblies so when looking for the rudder servo location I hacked away at what I thought it was only to find it is the optional elevator servo mounts in the fuselage (the factory places 2 arrows pointing in the same direction (what was that supposed to mean, E and R would have been better labelling :) ) The XT60 plywood holders are great but they only supplied 2 so if you run a dual battery system with ignition 3 would be required. The spinner template for the backplate is 30 degrees off the props I drilled and one pre drilled from DA (factory should include a note)- suppose it would be ok if you used their supplied template for both prop and spinner back plate. JMB canisters: Did you remove the coverings on the underside and use all 4 vent panels in order to mount the canisters? The 16 plastic rings - are this used to ‘surround and hold’ the canisters or are they for some other purpose - I can’t fathom yet as I don’t want to cut the covering without knowing (else I land up with un necessary holes (like my Fuse elevator hole which will get a decal to cover it). If you have any videos/pics of the canisters assembly/installation it would be greatly appreciated - JMB SET-3DHS-E540-106"-DLE130-REAR EXIT Once again thanks for the videos Cheers Wayne

[@cody_3335]

nice theta servos mate. C.H

[@joeytavora1270]

First one I have tried, looks good on the bench!

[@bretttremblay1050]

Enjoyed all 3 videos on build. I noticed the black cover over the fuselage Area you cut out for engine cooling. Did you make that it did it come with kit. I ordered 104” edge expect similar set up

[@joeytavora1270]

Hey mate, the black cover is included. Thank you for the feedback, it is appreciated. Enjoy the build!

[@piloto300]

Great video! Which electric screwdriver are you using?

[@joeytavora1270]

Es121 and than you for the feedback.