12. How to Engrave & Cut in LASERGRBL . ORTUR LM2 PRO !

I had a subscriber ask if I would do a video on how to cut in LASERGRBL.
I decided to do a video of engraving and cutting simultaneously with my ORTUR Laser Master 2 pro w/ LU2-4 (20 volt, 5.5 watt laser) :)
Important Tips :
Do not move your material you have engraved until you are done cutting. It’s almost impossible to get back into position!
Do not turn your machine off between steps.
NEVER leave your machine unattended !
I did forget to mention that I dialed my laser down one rotation with my Z height adjuster before cutting. If you are doing thicker material , you can dial it down even more.
Aha! The reason all my inside shapes did not cut first was that I had the “optimize travel” selected. It generalizes the entire piece .
I am not sponsored in anyway and I tend to use what I have. You don’t need the biggest and baddest things to start Laser Engraving ! On that note , I do appreciate if you would subscribe to my channel. It would be great to get paid for the time and effort I put into the videos. :)
I will be making the Christmas Ornament Templates available on my “Subscribers Only “ Facebook page.
More details on that and what you should have to begin Laser Engraving is in Video # 11.
Link for the actual Ortur site to purchase engravers and acessories. Don't be fooled by scammers!! Check out their new OLM3 w/ 10 watt laser that they have just launched!!
ortur.net/
Link for LaserGRBL from ORTUR with all libraries included:
ortur.net/page...
Referral Link for 5% off ORTUR
ORTUR.net/?ref...
#lasergrbl #laserengraving #ortur #orturlaser #artwork #howto #howtomake #woodsigns #xmas #xmasornament #lasercutting #lasercuttingmachine #lasercutter #disignscdn