First time I see a Singer with a knee lever. I thought only Elnas and Berninas had it.
@tksewingmachineandrepair42432 жыл бұрын
Pretty cool. Right??!! Back in 1927!!
@vaccavo2 жыл бұрын
@@tksewingmachineandrepair4243 Amazing!
@BlueMoon-tk4iw Жыл бұрын
I keep seeing flat knee levers, unlike the one you have there. I am struggling to find one similar to yours. Do you have any ideas where I can find one, please?
@tksewingmachineandrepair4243 Жыл бұрын
These knee levers are becoming harder and harder to find. I would keep searching ebay to find one. Good luck!!
@lindagieseler9566Ай бұрын
@@tksewingmachineandrepair4243 I hope you see this. I got one from Duane Sechser, 228 Devitt Dr., Harrisburg, SD, 67032.
@mikem970 Жыл бұрын
I have a 1929 model with the knee bar. How do I know if it takes the metal or plastic bobbin?
@tksewingmachineandrepair4243 Жыл бұрын
All these old girls perform optimally with a metal bobbin. Vintage metal bobbin, even better. Have fun with your machine!!
@DragonFaerie2393 Жыл бұрын
Open the slide door near the needle
@froobaba5 күн бұрын
I think i have this same one! Is there any adjustments for the speed? The knee lever seems rather sensitive 😅
@tksewingmachineandrepair42435 күн бұрын
IT could be that the assembly that controls the speed could be aged. If it is mounted beside the machine, then you can remove the cover, unplug the machine....and check that all the springs are wrapped around the ceramic block. If there is any corrosion, use alcohol and a qtip to clean the contacts. reassemble
@tlo42058 Жыл бұрын
Yay I got leather vest woot with patches
@Trogers918 Жыл бұрын
I have this machine, but it's encased in a table. How would I sew while it's encased? Where would I find the small bar, that the knee lever goes into? Do you have a video that shows how to clean it up. It used to belong to my grandmother. I've had it for about 6 years. I plugged it up in 2017 and it shorted the circuits, and I haven't touched it since. I've begun to sew leather and I want to possibly use it as a back up machine. thank you
@tksewingmachineandrepair4243 Жыл бұрын
Does the cabinet have a hole in the front of it? If not, then it takes a pedal. If you need the bar. try ebay. They are hard to find
@DragonFaerie2393 Жыл бұрын
I just bought a machine like this and its missing a cord. Can you help me locate a cord?
@ifsergioa Жыл бұрын
Hi couls you share a draw of the round open bar, I just bought the same machine, but it has not , best regards