20180920174707 1 1948-65 panhead cylinder offset boring after brazing up pin groove kwik-way by tatro machine
Пікірлер: 19
@netrhyda87616 жыл бұрын
You certainly have interesting machinery in your shop! Very nice!
@EL-xs1zy2 жыл бұрын
All the gear but no idea!
@mjm71873 жыл бұрын
I thought you might rough out the braze while you were still in the lathe to reduce the interrupted cut before using the kwik way. Not a critique. Nice witness marks you left on bottom of cylinder. will finish video now.
@scottbanks99896 жыл бұрын
I'm constantly amazed by the work that you take in. Most would have considered that cylinder little more than a doorstop. Couple of questions though, how are the wear characteristics of the brazed areas compared to the parent cast iron, and is the heat used in brazing likely to cause excessive out of round? Basically is this just a heroic effort at saving an original numbers matching piece, or would this be considered a "normal" repair suitable for regular usage?
@TatroMachine6 жыл бұрын
not for using in a bike. just testing some brazing rod and making a tool for mock-up down the road. tatro
@terrorofdemons11684 жыл бұрын
What model is that boring bar? I have a FWS.
@EL-xs1zy2 жыл бұрын
Looks like he learned how to use his machines by watching KZbin.
@TatroMachine2 жыл бұрын
not likely, i am way older than youtube. try again. that goes for the internet too. tatro
@nealelliott6 жыл бұрын
Do you have a video of you installing a sleeve in a damaged clyinder?
@doubledown93336 жыл бұрын
Hey Tatro,this was really Boring.
@TatroMachine6 жыл бұрын
at least i wasn't cutting you up. tatro
@petschannel41926 жыл бұрын
It's not work properly cause some little dots of welding of bras so piston rings may be give space to oil over all nice work
@TatroMachine6 жыл бұрын
just a welding test. they are not for use. tatro
@jiveturkey99936 жыл бұрын
Nobody makes replacement cylinders? Or is this kind of a numbers-matching deal?
@TatroMachine6 жыл бұрын
who says replacement parts are any good. old stock parts are far better than most of the junk they make now. yes it is a numbers deal and being a oem part really does matter to collectors and people in the know. how can you own a real harley when all the parts in it are made in china or taiwan. tatro
@jiveturkey99936 жыл бұрын
Ok. That kind of sucks no one's making good replacement parts.
@petschannel41926 жыл бұрын
@@TatroMachine i like this work my passion is this work
@wwooster41646 жыл бұрын
What's the benefit of running a cylinder in a boring bar, as opposed to on the Mill? is it just a matter of it being easier to hold in that clamp as opposed to on the mill table?
@TatroMachine6 жыл бұрын
a cylinder boring bar is made to do one thing only, bore cylinders. it is a very accurate and rigid machine that does its job very well. a vertical knee milling machine is a good universal machine that does alot of things good. being a jack of all trades it doesn't do any one thing very well. tatro