Рет қаралды 10,156
Installing the rear hub bearing stack in a 71 BMW R75/5 SWB.
The steps are below:
Removing the stack is the exact opposite of installing.
1. Insert the axle the opposite way into the hub (from the right side of the hub).
2. Lock the bearing stack together using a plumbing nipple that should be found at most any hardware store (3/4"x4"). It may need to be cut down, mine did.
3. Heat the aluminum wheel hub to around 200-250 degrees using a heat gun or propane torch. Must be very hot to expand the aluminum enough. If the stack doesn't come out (or go in) easily, it is not hot enough.
3. Using a rubber mallet, gently tap the bearing stack out (or into) the hub. Tap gently on the axle from the right side to push the stack out (or in) the left side of the hub.
I followed the instructions on Mr.Duane Ausherman's website below. He has a very good site with lots of excellent information about these old airhead BMW's:
w6rec.com/duane...
Good luck!