1980-1991 Ford F150 and Bronco tilt column turn signal switch installation

1980-1991 Tilt columns refurbished Ford F150 F250 F350 and Bronco www.ebay.com/u...
Turn signal switch for Tilt columns 1980-1991 F150 Bronco: amzn.to/3KC8073 (Amazon)
This switch has the correct color wires and length. You will need to transfer the black plastic ring with two spring loaded contacts (cancel cam) from your original switch to this switch to get the cruise control and horn to work. No one makes the switch with the cancel cam ring correctly with the copper colored contact for the cruise.
Actuator: amzn.to/3VaBOfO (Amazon)
Lock cylinder: amzn.to/3KD8g5H (Amazon)
Long nose circlip pliers: amzn.to/3xdJ5DQ (Amazon)
These pliers are great for the circlip under the ignition lock cylinder.

[@richardksmith]

I've watched a few of these videos in anticipation of doing this job on an 86 F250 and this one is BY FAR the best / most useful and the best videography. Congratulations and thanks, Bob.

[@Ralphieisthegreatest]

This was VERY helpful! Thank you so much Bob!! Best Ford TS switch replacement on You Tube.

[@temoaguirre820]

Very detailed!! Awesome video

[@martinbeville7295]

Excellent best video I've seen on this..

[@DocHoliday-to6kp]

Very Helpful. Thanks for sharing.

[@richardbower641]

Thanks for the tips! This was really helpful. :)

[@rodrigabtonio2203]

GOD BLESS YOU BROTHER, THANKSssssssssssssssssssssssssssssssssssss

[@mackendw]

question on the wire bundle for the multi-function switch ...when the new one is pushed thru the hole in the steering column hole, there is a small white wire for the gear indicator. is the multi-function switch wire bundle supposed to be OVER top that white wire? or under it? thx.

[@drat2182]

The original switch has two pins on the turn signal canceling ring. The new switch only has one. What does the brass spring loaded pin on the original switch do?

[@jamesperkins8569]

Can you make video steering lock actuator?

[@bobclark9080]

I will work on that. The actuator needs to be modified slightly to work properly, since the reproductions are a bit too big and get jammed up unless you sand them down. I will show you how soon.