1GR V6 4.0L Engine Cylinder Head Bolts Torque

1GR-FE V6 4.0L Engine Cylinder Head Installation And Bolts Torque Setting Of Toyota Land Cruiser Prado, Land Cruiser, Tacoma, Fortuner, Tundra,4Runner And FJ Cruiser
#MayoCarsDR
#1GRcylinderHead
#HeadBoltsTorque
1GR 4.0L Engine Disassemble
• 1GR-FE V6 4.0L Engine ...
1GR 4.0L Engine Rebuild part 1
• (Part 1)1GR V6 4.0L En...
1GR engine rebuild part 2
• 1GR-FE V6 4.0L Engine ...
1GR engine rebuild repair manual 📚
• Toyota V6 4.0L 1GR Eng...
1GR short block rebuild repair manual 📚
• TOYOTA FJ Cruiser 1GR-...
1GR all Engine control sensors location
• 1GR-FE V6 4.0L Engine ...
1GR Fe V6 4.0L engine timing marks setting
• 1GR-FE V6 4.0L Engine ...
1gr brand new short block inspection and firing order
• 1GR-FE Short Block Ins...

[@whiskeymountainwood]

Great video! I am going to be doing this in my 06 Tacoma really soon and the engine will still be in the truck when I do it. I was worried about tightening the bolts 180 since I'll have limited room in there. This three step method is going to make it way easier.

[@MayoCarsDR]

Thanks for comment

[@gersonhay984]

Keep them coming.

[@Avatheskibidiaplphadog]

So my head gasket failed to seal at cyl #2 and #6 was the problem . I noticed you went 90° instead of 180° on the 2nd step. Im thinking you did this to allow streching for the head bolt , right ? My cylinder head was decked and all , and i didnt have problems with that area , so the block should be good. Its a DNJ and im putting a Toyota HG back on after.

[@yoyimarti2864]

Awsome video 2 the T!!!! Thankx

[@MayoCarsDR]

Thanks for comment and watching Video

[@danwillii4333]

What is the over all torque after the initial 36 n.m.'s when your stretching the bolts, after turning the extra 90 degrees I would like to know if you catch this

[@MrVel46]

Did you use a new set of head bolts or reuse the old ones?

[@MayoCarsDR]

Reuse

[@lifeisbutifull2093]

Best of luck

[@DanielAguilar-ws2qd]

En mi caso apretando así se jalaron las rosca del block.

[@محمديوسفالقوصي]

تمام. ميه ميه. ...

[@chrisfort7340]

Excellent videos! Super helpful! Do you have one rebuilding the heads from this motor? Valve seals? Thank you from Los Angeles.😎

[@MayoCarsDR]

1GR V6 4.0L Engine Rebuild Of Toyota Land Cruiser kzbin.info/www/bejne/a4PKd5-cidKmg6M

[@rudyrey5600]

Question..do you need silicone on the corners? What is the white that you put on the corners?

[@MayoCarsDR]

I am Applying silicone

[@populationentertainment460]

Is the silicon needed? If so, what kind to use?