2006 dr200 se clutch replacement

[@zgeraldo84]

Thank you! Excellent video!

[@Irregular503]

Thank you for taking the time to show this. Much appreciated.

[@jackreeves4094]

Thank you man great vid

[@chrisklein4366]

And did you use the gasket case or replace it

[@bhushanmanamatya8304]

Hi, I’m looking to change the clutch plates on my 2011 suzuki dr200se. Do you have any recommendations from where I can get the ones that would be a perfect fit for my bike? Thanks😊

[@monkcheetah8203]

Very helpful thank you!

[@mudbutton2]

Thanks. Not too hard.

[@wolfganghokenmaier]

Thanks for the video. Did you have to replace the seal for the clutch cover case or is it generally reusable?

[@carloskingmancilla1858]

Cuántas pastas y discos lleva el cluch. Tengo una DR200S 2015. Gracias.

[@chrisklein4366]

Jake do you know the torque spec for the outside case the ones that are all different sizes

[@sybetronw3029]

Hey Jake! Thanks a lot for the video, it was vert useful for me. I have a question I was hoping you could help me with, since there are not a lot of video’s on yt about this bike. I took my engine out a little while ago and when I put then engine back on the bike, the clutch lever wouldn’t return. There’s no tention whatsoever and it just hangs lose. Normally there is a spring that makes sure the lever returns when you let go of it but I just couldn’t seem to find one. Is there any chance you know how this is done on your bike? I just can’t figure it out so it would be a true life saver. Thank you in advance!!

[@jakeclifton1818]

Hey yes if you look up toward the headlight assembly/ front fork there is a little rubber boot covering up another clutch adjustment tumbler if you can’t find it look up dr 200 clutch cable adjustment and if that’s not it I would take the side cover off and inspect the clutch but more then likely it’s that cable adjustment. There really shouldn’t be a spring on this bike at least all it should be is cable adjustment

[@sybetronw3029]

@@jakeclifton1818 Thank you so much! Works perfectly now! Can’t expres how grateful I am!!!

[@jakeclifton1818]

@@sybetronw3029 really glad that helped man

[@revolutiondreaming]

Hi. Did that EBC kit come with metal plates included or just fibre clutch pads? Do you think it's recommended to get a whole kit and replace everything or can you get away with replacing just the pads only? Thanks.

[@jakeclifton1818]

Yes it included the metal

[@revolutiondreaming]

@@jakeclifton1818 Thanks for the reply. Which EBC kit did you use? I see on the box it was the DRC Series, which part number is it? Thanks.