Рет қаралды 19,330
Here I show how to remove and install the drive belt or serpentine belt in your Ford Explorer Sport Trac this one's a 2008 but this will work for explorers 2007 through 2010 with a 4.6 L engine. if your belt is going bad it'll either wine Screech or make lots of noise, sometimes it just breaks. You can check to see if you need to change your serpentine belt by looking at the pulley where the belt bends and if there's cracks in the belt it's a good time to go ahead and replace it. also make sure all of your pulleys spin freely, except your crank pulley will not spin freely, if any of those lockup it will cause your belt to break or Shred. if you smell a burning smell or there's built up belt residue it's a good indicator that a pulley locked up and broke your belt. another thing I see a lot is water pump go bad and the belt will fall off.
the belt you will need, make sure it fits with Amazon's car fitment tool...
amzn.to/38qyu8j
a whole belt and pulley kit...
amzn.to/2IYUEFS
Other stuff I commonly use in these videos…
Milwaukee Ratchet: amzn.to/2Fzf839
Regular Ratchet: amzn.to/2FxYsZO
Milwukee Impact: amzn.to/2X5c5W2
Socket Set: amzn.to/2IOTERA
Socket Extension: amzn.to/2XxCIaI
Swivel: amzn.to/3dYJieE
Floor Jack: amzn.to/2LmGM7d
Jack Stands: amzn.to/2XwcDbX
Wheel Chock: amzn.to/2J6Sjog
Permatex Rtv/Silicone: amzn.to/2Qv6aJK
The tool I use to turn on parts like headlights, starters, fans, and more: amzn.to/2Oz8YUy
Follow me on Instagram 😁😁
/ jordanfixbook