2007-2015 Mazda CX9 with Bose - Installing a Sony XAV-AX5000 Double-Din Stereo - AXXESS AXTO-MZ1

In this Video, we demonstrate the wiring for a 2009 Mazda CX9 with Bose amplifier. Most Mazda OEM amplifiers can be retained by sending a simple turn-on signal to the OEM amp. The CX9 and CX7 are different so you will need a separate amp turn-on module. In this video, we use the AXTO-MZ1 to connect the wiring for the CX9 to the connector for a Sony XAV-AX5000.
How did we retain the backup camera? See the adapter sold here:
www.autoharnes...
Find information specific to your vehicle here:
www.autoharnes...
All of this information has been reviewed by AutoHarnessHouse.com engineers so we know it's accurate!
Pick out the right Sony headunit for your Mazda here:
www.autoharnes...
The pre-wired AXTO-MZ1 adapter is sold here:
www.autoharnes...
If you have any questions regarding the wiring please do not hesitate to ask us! We can build custom plug and play wiring if we don't have a product offering to meet your needs.
Extreme Trap Racing Music | Power by Alex-Productions | / @alexproductionsnocopy...
Music promoted by www.chosic.com...
Creative Commons CC BY 3.0
creativecommon...

[@jeremyrangel8138]

My factory stereo has a second connector, which I assume is for the stereo controls, but I also think it connects to the CAN, because with the factory stereo out of the car, the AC doesn't work.

[@hlanceboyd]

Also, it is possible to use the existing factory microphone in the car and hook it up to the new JVC head unit

[@OLD_Dziadzior_GARAGE]

Hi, question I have bose audio with navi from cx7 2008, and I tried to test the system on the table I have connected audio unit amp and speakers , radio its working fm/cd but there's no any sound from speaker, can you advice?

[@autoharnesshouse]

The Mazda amp is turned on with the CANBUS. Depending on how you've got those wires connected, this could be why it isn't coming on. Are you using the OEM Mazda amp?

[@OLD_Dziadzior_GARAGE]

​@autoharnesshouse, yes, it's oem Bose, amp, radio, speaker. As far as I know its conect to can bus

[@OLD_Dziadzior_GARAGE]

​@@autoharnesshouseI contacted same way like should be follow by diagram, but how to make can bus signal to make it working without car ECU etc. From what ever they have signal.

[@autoharnesshouse]

I'm guessing that the CANBUS signal is incomplete without the car's CANBUS signal being present. Something I've done before with these systems is a hotswap, where I have the OEM system connected to the car and without shutting the car off, I disconnect the OEM headunit and swap in the aftermarket system (using the Bose adapter that we show in this video). Perhaps, you could try connecting the CANBUS from the car for the initial setup and disconnecting it once it's running in a similar way?