2009 Ford Focus Blower Fan Concern

[@vanbilly8387]

Thank you for the informative video. Clean and clear instructions make checking into the problem much easier.

[@paycheckmonster]

Thanks for watching. I'm glad I could help!!

[@tejindersidhu5639]

You saved me atleast $100. Thank you so much.

[@paycheckmonster]

Thanks for watching!!

[@user-yl3lb5uk3g]

Well detailed video. I tried to detach the wire clip from my blower but it won't come off. Seems stuck. Tried everything possible even pushing the removal clip. What could I do?

[@paycheckmonster]

Sometimes they be difficult. Try pushing the connector in, pushing the release tab and pull back on the connector. It should come. Check to see if the connector is burned. If the plastic is melted the connector end and the blower motor would have to replaced anyway. Thanks for watching. Good luck!!!

[@yanirs2940]

Thanks for such a great video! How did you disassemble the airbag cover? Did you remove the air bag before reaching the AC unit?

[@paycheckmonster]

No need. Thanks for watching!!

[@yanirs2940]

My bad. Could you please write the product ID for the resistor? I cannot find where to buy it

[@jamesmahle1259]

Nice camera work. At 1:45 is that a blend door actuator to the right of the flashlight? Working on a 2008 Focus no heat (blower and resistor good) and have ruled out everything else (from T-Stat to Core) and I think you just resolved my no heat problem! I only thought it had the two on right side...

[@philipunger6507]

Thanks for the information. I have a question for you. I have a 2008 Focus with the blower motor that is stuck on low. I've changed the resistor, but there's no change. Any ideas?

[@paycheckmonster]

I would start by check fuses #37 and #15 behind left side of dash. If ok, check volage with key in run and fan speed set to high at yel/blu wire at resistor. Should have bat voltage. If no voltage, suspect fan speed switch. Also check for ground at blk/wht wire. Thanks for watching.

[@philipunger6507]

@@paycheckmonster Will do. Thanks.

[@ruccimane2486]

Would this work on a 08?