2012 Buick Enclave Brake Light Switch / Brake Pedal Position Sensor

[@T_ROLLA_DACOLDEST]

Thanks to this video I did it myself 💪🏿

[@tommylord6313]

Thank you so much just saved me 150 and much more wow🙏🏽💯

[@Evdath]

Thank you

[@msgaming71601]

Hey sir! So I have a 2008 Buick Enclave CXL 3.6L V6. I went to to change my break pedal position sensor, and the sensor is there with the wire connected to it, however the other end was not connected. What does the other end connect to. Not the end that that connects to sensor but the other end

[@TheGAutomotiveAndMore]

I really do not know. Its probably a for some type of option that your car does not have.

[@angelf9800]

What if you don’t have a high tec scan tool.

[@TheGAutomotiveAndMore]

You will not be able to reset it and the brake lights will stay on.

[@nadinefernandez8752]

What bolt is that your taking off?

[@TheGAutomotiveAndMore]

It's at 1:15 in the video

[@pertavionadams3590]

How did you know you had to calibrate the new switch??

[@TheGAutomotiveAndMore]

The brake lights would not shut off after I installed the new one. Thanks for watching

[@mikecirimele]

Which Autel scan tool did you use?

[@TheGAutomotiveAndMore]

It's a Autel MS906TS. Thanks for watching

[@Loltag11]

Where u buy your scanner

[@TheGAutomotiveAndMore]

www.jbtools.com/ Cheapest place to get a Autel

[@FriedAudio]

You're very fortunate that it wasn't a 2011 Regal with the same issue; you would have had to remove the entire dash to get to the brake assembly. GM SB-10045319-1529