Thanks for finally being a fucking person to show this kinda stuff 👌🏼 I have a 14 so I've been curious
@wileecoyote41168 жыл бұрын
good video, thank you. When you say "be careful" with the solid steel idle gear what did you mean? dont put it in a vise and hit it as hard as you can with a hammer? Dont hold it on a disc grinder for 20 minutes? dont throw it in a lake??
@neiljackson58016 жыл бұрын
I think you had rebuilt incorrectly. the two washers shoud be outboard of the cog
@mikeduffy36703 жыл бұрын
What’s the cog?
@kencalip61296 ай бұрын
Witch washer is up against the clutch cover?????? Flat or spring
@Sadrazampower1Ай бұрын
do you mean that the last (thickest) plate should be placed in the shallow grooves? i often saw that the thicker plate is placed at the very beginning? can you please explain to me the correct order and method for cbr1000rr 2009
@michaelschuler73978 жыл бұрын
also you need to soak your friction plates in g4 oil overnight before you install it
@neiljackson58016 жыл бұрын
the washers should be outboard of the cog I think that's why you got the noise
@CBR-C336 ай бұрын
is the left of the right thread on the 12 tooth bolt?
@DimazPR6 жыл бұрын
Need help. I replaced the clutch cover and every time I try to put it back on the startor shaft doesn’t catch and it’s been a couple times now. The washers according to the manual goes against the cover if I’m not mistaken
@4autodetail7187 жыл бұрын
I have 2008 cbr1000rr that the clutch is stuck do you think that because of it the gas pump does not prime? I can't start it up at all ..
@dronelife25057 жыл бұрын
jose sanchez no i dont believe so. have u done alot of burn outs cuz just like a car if the clutch heats up and pretty much catch fire it burns it together where they get stuck could be ur problem. also will the bike turn over and the bike move? if not the clutch could be fine. check ur kickstand switch. I had that problem but the bike wouldn't even try to start
@4autodetail7187 жыл бұрын
The bike moves only on neutral .. I will check the kick stand too.. But whe i put the bike on first gear and apply clutch the bike does not move is like if I where not applying the cluctch ..
@dronelife25057 жыл бұрын
jose sanchez maybe the clutch needs adjusted. I'm not sure bud
@PJGrant859 жыл бұрын
when you did this did you have to replace any gaskets at all
@dronelife25059 жыл бұрын
no. there's no gasket. I put honda bond for gasket seal
@andrewhoehner53172 жыл бұрын
This video is abosuletly no help at all. Pull the plates and document how you put them in.
@davidcrawford55792 жыл бұрын
This is what Ive been waiting for
@justinrichards16603 ай бұрын
@andrewwhoehner5317 it’s a super simple process and an FSM can be found online for free.