2015 Chevy Trax Bumper Repair and Installation Tips!

Save those old credit and gift cards....they can be a huge help in repairing a tore bumper without spending anything!

[@NonnoTony48]

Thanks so much for your Tutorial, I followed your instructions and managed to replace the front center Grille on my 2017 Trax, I had some difficulty removing the bumper but then I remembered The 2 Screws at the top inside the wheel arch, removing them the bumper came off easily, it took me about 2 hours to do the job, but it also included the oil and oil filter change, THANKS SO MUCH

[@chsc99]

Hi. I have a German Opel Mokka(twin of Chevy Trax). Ivcant remove the bumper. Can you Show me These screws? Thanx from Germany

[@NonnoTony48]

I think the screw you’re referring to is on the 12.09 minute on the video. Good luck

[@cadaverdogblix7448]

Ive got to replace the radiator on my trax, thanx for showing how to take off the bumper, which you have to do, no way around it 😦

[@floydswitzer6556]

Removal video needed

[@edhornsby7757]

2016 rear bumper cover removal ,and replace

[@poolbob8776]

I think the thickness of the wooden blocks , you used, may be keeping the drivers side , from snapping in. Thanks for the video.

[@JJ_Curtis]

If you have a chance, please upload a video of the order of opening the front bumper. Thank you Sir.

[@midnightauto9996]

Will do if I get another Trax with front end damage. It is a fairly straight forward process. Just be careful to note where all the fasteners are located to make removal of the bumper go smoothly.

[@JJ_Curtis]

Midnight Auto 999 Thank you Sir. Please take care.

[@davidconley3610]

Ingenious repair using credit cards!

[@midnightauto9996]

If I recall correctly there are two nuts on the back that need to be removed. Also I think the emblem has adhesive to help hold it on. Use a heat gun to help loosen the adhesive,

[@angunotv]

Hi sir I just want to ask if the chevy emblem of trax is removable outside or I have to unscrew it inside?

[@abdahorn21]

Hey, can you remove the bumper lip to gain more ground clearance ? Are those nuts below for that ?

[@midnightauto9996]

The problem with removing the lip is that there are plastic panels and covers that are secured/anchored to the lower lip. It would jeopardize the integrity of all the lower panels.

[@harrygaggles1414]

how to do you easily put the fog light covers on? Do you need to take off the bumper to put it?

[@midnightauto9996]

If I recall correctly , you should be able to loosen and move the front edge of the inner wheel well and access the back of the foglight.

[@mihelsatorreon3527]

Please talk in spanish mi friend. I don't undertand English. Tank so much. From Torreón Coahuila México.

[@justintuck3]

What is the sensor for on the back of the bumper?

[@midnightauto9996]

I believe you're looking at the ambient air temperature sensor part number 25775833

[@justintuck3]

@@midnightauto9996 Thank you. Your video was very helpful.