2016 Nissan Sentra: Brake shoe replacement

[@droneview9580]

Seriously, this video is a clear example of how experience is supposed to be passed on to new learners, as myself. Thank you for the video.

[@melplishka5978]

Yep well done kimo lol

[@michelrobi1288]

Thank you so much Phoenix for the trick on the parking brake cable. It was always a pain in the ass for me to reassemble this. But the way you’re doing it is very easy, thanks.

[@chitowndj72]

This was THE BEST, CLEAREST and MOST ORDERLY method of replacing brake shoes on a 2013-19 Sentra that exists on KZbin! Hope it gets tons of views. The other videos make it so much more difficult. Nice job BE HANDYMAN!

[@taoshyr]

Thanks 🙏

[@pauln6150]

Thank you! That cable method was so easy. And I followed with the longest thinnest screwdriver I had and it made it go so much faster putting those springs on rather than using players. Again thanks for the upload.

[@charlireone]

I wish I would’ve seen this video first ! You made it easy compared to the others!

[@SCAMATICS777]

Good job. No words needed. I'll be using this video. I seen another similar but you did it faster and better.

[@johncollins8304]

I LOVE the way you got those pin clips off. ...pause..... I HOPE I'm going to love the way you put them back on...

[@joeyd4306]

Best video yet

[@bill7774]

That was an amazing job. You made it look easy.

[@scottmurray2434]

Great video. The best video on KZbin every other video they had no idea what to do or over explained like you never seen a break before.

[@AH-cx5bs]

Great technique and very helpful, bro.

[@iamfig23]

No greasing on contact points?

[@budgetrydes4820]

Thank you 👍.

[@sidneycarpentero5429]

Great job ty now I have an idea. It's very helpful brotha

[@ron_olla]

This video was amazing

[@victorgutierrez5826]

I did everything like you did , but when I try to push the wire was to HAARDDD!!! I think I need a SMALL screwdriver like yours.. I connected both shoes with the wire , I put the clamp and then I put the other shoe on the caliper and push back, then I put the adjuster(People have to be careful in how this part goes because I put in the wrong position before when I finish it and put the tire back ...I notice when I make the other side of the breaks....😧😧 and then I have to do again to fix the problem ( take a Picture in how goes before take off the adjuster from the shoes) ...thank you for show us how to fix it.

[@glockman8091]

Exactly how i did it 👍🏻👍🏻. Awesome.

[@erwinpurigay7417]

What about the hand break did you adjust also?

[@PamnasMaghanga]

thank you

[@dannysautorepair]

Great job , Is this the same set up for a 2018 sentra s

[@DudeguyASMR]

What are you checking for at the end when spinning? TIA

[@whooahhbrudder]

when u put the adjuster back you want to adjust the pads to JUST barley make contact (have no space) between the rotor and pads, so he was just making sure it was a snug fit and didn’t have any play on the rotor.

[@joaquinvilla-cortes9248]

Buenisimo lo haces mirar Bien simple grasias..

[@tonyjohnson8929]

That top spring went on waaaaaaaaaaay too easily. Nice for you

[@froylanmiranda7362]

Question does 2016 Sentra SV have rear shoes or pads thank you

[@armajay86]

Thank you…

[@lylejohnston4125]

Got brake dust? Spray it off with a water hose first or use brake cleaner. Your lungs will thank you.

[@southerncali88]

I swear to God whoever invented drum brakes deserves a special place in hell.

[@erickrojas3560]

Cake work

[@daviddavido5872]

Why is my drums stuck on

[@dawgmentalitypodcast4923]

How did you get it off

[@megaman786]

It's stuck on from too much glue. To get it off you have to weld it.

[@joelsalazar906]

🤫🤫🤫🤫🤫