2018 Toyota Camry - Codes P0036 and C1A40. ICS Message is on. No cruise control **See description

2018 Toyota Camry. Unable to use Cruise Control.
P0036 Bank 1 Sensor 2 Heater Control Circuit Open
C1A40 Refer to OEM repair information for code description.
Before chasing C1A40 look at into check engine light code first. See if check engine is causing ICS message to prompt.
ICS - Intelligent Clearance Sonar.

[@oscarochoa8475]

I had the same problem hoping it wasn’t something worse. This video truly helped than you soooo much. Blessings 🙌🏼

[@joseleysa5137]

Excellent Job man, but you forgot to post the OEM part number of the sensor. Keep up the excellent job.

[@waqasazmat81]

Sorry, you are right. Dealership should be able to give a part # as well.

[@LEFTY2GUNZ401twoGUNZ]

I’m getting the same thing right now

[@vazquez5856]

So it was a bad oxygen sensor ??

[@waqasazmat81]

Yes it was.

[@litxcapscarti1519]

I have this same issue. However, sometimes when I go to crank my car the light does not come on at all until I cut the car off again. Do you think that it could be the same issue?

[@waqasazmat81]

Sorry didn't quiet get your question.

[@litxcapscarti1519]

@@waqasazmat81 I have the same issue but I’m getting a P26CB code

[@nidalalqannas1264]

I have the same problem what did you do?

[@litxcapscarti1519]

@@nidalalqannas1264 found out it was the electric water pump with the p26cb code it’s an electric pump easy to replace just have to removed alternator to get to and literally 4 bolts and a harness to take off

[@jayally1900]

I just got those lights on my Camry

[@joseb2923]

Just test the sensor before install for ohms 😂 faulty sensor 👍🏻

[@Alberto-or7js]

Bought a used 2018 Camry with 60k miles. I do a lot of city driving with it. At about 95k miles I get this same problem with ICS and checkengine with o2 sensor code. I changed o2 sensor and everything cleared. Cars been good until a few months back. It's at 160k miles now. This time no checkengine light and no codes on the scan tool, but dashboard will randomly start showing ICS Malfunction along with Radar Cruise Malfunction, Blind-Spot Monitor Malfunction, Headlight System Malfunction, and Pre-Collision System Malfunction. Not sure what triggers it, as I'm driving the same as always. These warnings turn on probably 30% of the time i'm driving the car and they all come on at the same time. Car drives like new, no weird noises or anything. Been having this problem since about 150k miles on the odometer, it's at 160k miles now. I notice headlights will still work if i turn them on when these warning lights are flashing on the dashboard, but they will delay by 5 seconds or so to turn on. Blind-Spot Monitor and Radar Cruise stops working completely while the warnings are flashing, but otherwise will work perfectly when the warnings go off. My guess is it's probably a bad ground wire or a bad relay? Maybe I should change the same o2 sensor out again? This time I don't have any codes on my scan tool to go off of unfortunately.

[@rch1jr]

I’m having this issue CarMax said it was gas cap not closed properly Got the car back and the next day it came back on

[@guac666]

Hello, I got this problem. So what exactly do I need to change? Can you send me the part number or the exact device that needs to be changed? Please. Unfortunately, my English is not good enough, so I didn’t get the info.

[@waqasazmat81]

Call your local Toyota dealership and ask for the oxygen sensor for bank 1 sensor 2 (providing if that is the fault code you are getting P0036). You have to give them the vin #. Hope this helps.

[@guac666]

@@waqasazmat81 thanks a lot, I will try

[@waqasazmat81]

@@guac666 let us know if that corrects your concern.

[@عبدالرحمن-ر3ظ7ه]

@@guac666do you fix it ?

[@guac666]

@@عبدالرحمن-ر3ظ7ه hello mate, unfortunately not, I’ve changed the sensor, but still got the problem

[@ysitrim88]

Thanks, this has helped me so much! Why would a manufacturer do this is beyond me.

[@waqasazmat81]

Honestly I am not sure, things are not getting better. Manufacturers do not want shops or DIYs to work on the vehicles anymore. Shops spend so much $ on the scanners then the service info and tools. But its never enough. Glad it helped you out.

[@ysitrim88]

@@waqasazmat81 Sucks that's just the world we live in now all about the money!

[@danman9017]

tks