Could you go over how you connected your boards via wireless? I'm new, and a little unsure how that works. Thanks
@Bigrob44411 ай бұрын
With the Kulb boards they have an onboard BeagleBone Black computer. Instead of plugging in an Ethernet cable I have a wifi antenna. Then in FPP (on that controller) I tell it the wifi credentials and it connects automatically.
@galaxyrider123 жыл бұрын
Awesome! I'm fairly new to this and was curious why you swapped from the Falcon's to the Kulps? Thank you in advance
@Bigrob4443 жыл бұрын
I ran an F16v3 and with 4 receiver boards. This requires a lot of cat 6 cables to run across the property. With the Kulp boards there are no data cables, all the data is transmitted wirelessly via the wireless Access Point to each controller. Plus the Kulps have built in FPP with makes controlling and setting them up 100x easier than the Falcons
@adanraya3960 Жыл бұрын
Can you go over you DMX setup for the dumb RGB trees...
@Bigrob444 Жыл бұрын
What specifically did you have questions about?
@gibsonfamilylightshow3 жыл бұрын
How do you mount the pixels inside the PVC pipe? Thanks!
@Bigrob4443 жыл бұрын
Just push them through the pipe. Friction holds them in