2023 Indian Challenger Fairing Removal first step in Painting the bike. pt1

[@dennismims2999]

I've got a 2022 Pursuit Limited and I did a handlebar (KST 4" pullback) change, so I've removed the faring during that process. I will offer you a little piece of advice just in case you haven't already done it. When reattaching the fairing don't tighten any of the screws more than a couple of threads, and install all of them before you begin to tighten any of them. And then there's the sidecovers, seat and gas tank while doing a handlebar change. If you have heated grips be careful trying to get off the clutch side grip (too much grip glue) and destroyed mine to the tune of about $150. Anyhow, good luck it's all about getting into it and personalizing your bike to make it yours.

[@jdubb67]

Thanks for the advice, I did notice pulling off the fairing that it is a "little" flimsy so making sure all the bolts are in place before tightening is gonna be a must. The bike is completely stripped now tank, side covers( biggest pain so far)(video will explain why) front Fender, rear fender. I'll be posting them as they are edited over the next couple of days/weeks thanks for watching

[@jamescripdizzle]

Thank you

[@jdubb67]

Thanks for watching

[@kyleprater7694]

I used this video to help me thank you. Has anybody noticed a lot of cross thread on their bike. I work on an auto assembly line and I know cross threads and almost every bolt or screw I pull of is cross threaded.

[@jdubb67]

Glad the video helped I didn't really notice much cross thread on mine