220V AC FAN CONVERTED TO 12V DC

[@christiandeleon2987]

Pwede ba mas makapal na coil ang gamitin idle?

[@martynicolas1625]

Hi sir... Ano napong update Neto?, okie lang ba deritso na salsa sa 12volts battery?

[@dhansantv395]

hindi po need po ma converte to ac ang dc supply

[@martynicolas1625]

Ask lang sir... Pano kung walang adriuno.. gagana ba Yan kahit h bgride module lang?

[@mandyasdillo5777]

Anu size ng magnetic wire pinalit mo sir, 0.6mm?

[@mrheart1139]

Hi sir gusto ko sana malaman kung ilan ang kain ng kuryente 12v vs 220v na clip fan sana makagawa kayo ng video

[@dhansantv395]

hellow sir sorry sorang bc wala napong time gumawa ng mga video for now but in my opinion mahirap nang napatan ang efficiency ng 220v clip fan sobrang tipid na nila i think kung tipid din lng eh stick napo tayu sa 220v clip fan pero kung gagamitan nyu sila ng battery then convert nyu pa sa 220v ac yung batt before sa clip fan much bettery mga 12v clip fan na kayu para direct na at mag matipid kesa madameng heat waste sa convertion portability at oang emergency mas panalo din ang 12v clip fan

[@mrheart1139]

Ngayon ko lang nabasa btw salamat sa pag reply gawa pa kayo ng mga ganitong klasing video full support

[@punjabipunjabde1631]

Good

[@kentoytv4215]

Boss ano po ba size ng original magnetic wire boss?

[@re-voltanims2305]

Sir sana ma Notice kasi pwede na yan gamitin wind turbine lagyan ng rectifier para ung AC na lalabas sa Fan maging DC, then lagyan na lng ng Charge control at para maka charge Lead acid Battery at LifePo4, ask q lng sana pag inikot nyo po ung fan pa check ng Output Volts Amperes kung ilan? Balak q kasi gawin wind turbine yang ganyang Fan sir kaso wala pa q time...

[@dhansantv395]

Nako sir hindi kona po chineck kasi kung ganitong motor gagamitin inang una yung mahina lng yung magnet, then pasok ng tubig yung loob mangangawalang ang stator. Then yung frame quality sir di nya kaya matagal na initan or unalan madaling magagato pagka plastic nya Pero I think sa config ko kaya ang 5-10w sa magandang hangin masyado pading maliit para sa effort sir 😅

[@re-voltanims2305]

@@dhansantv395 salamat sir sa reply 🙏🙏

[@samikhandurrani1]

we heve not this conacter ples I heve this pen but 220 v there is no lhit in my veleg so we heve Soler

[@dhansantv395]

Sir I can't understand

[@jayveecastillo9853]

Galing ng kua ko

[@Mark-ce7di]

Boss bka pwede convert mo nlng sa 3 phase then esc ang gagamitin.

[@dhansantv395]

Two poles lng po ang iron core nya hindi po applicable ang 3phase config. Boss

[@samikhandurrani1]

can you send me esy installation vedio

[@dhansantv395]

Installation is a boring one. If you need it for proof I don't need to prove any

[@matzkievalsur1770]

Ano ang mga kailang gamit

[@dhansantv395]

Optional soldeeing iron .6mm wire copper wire (wind as long as it fit the booben Hbrige driver Arduino Some wire and a 12v power supply My setup consumes 6watts maximun efficient napo can run by a 12v batteries overnight

[@temih21]

mas convenient padin ang 220v dahil 5watts to 10watts lng ang consumption mo per hour unlike sa 12volts dipende sa amphere na gagamitin mo. ex. 12v 2mah = 24watts.. kaya mas makakatipid padin ung original nya 220v 5watts

[@FirstLast-jf9on]

ngeh, di ma'connect ang DC directly at kailangan gawing AC?? Eh d hindi mo na'convert to DC yung fan kasi AC parin needed na power.

[@dhansantv395]

If you watch the video you'll see how ill make a controlled pwm signal and an full h-briged system to oscillate dc supply to make alternating current which my motor need.

[@dhansantv395]

Ever wonder why there's an arduino board on thumbnails? Hehe

[@FirstLast-jf9on]

@@dhansantv395 even AC uses arduino board. All you did is "Change the Coil" but never converted it to DC that's why you need a DC to AC. Yes, you're source is DC. But still, the fan still needs to use AC to run. That's why you need to convert DC to AC and connect it to the fan. Imbes na nagpakahirap ka na tanggalin at baklasin yung fan, bumili ka nLang sana ng Battery at Inverter tapos isinaksak mo yung fan.

[@dhansantv395]

@@FirstLast-jf9on do you know how much I spent to that coil rewind? Buying a reliable converter alone it too much expense for such a small project converting DC to low voltage AC is such an easy task that's why I'll go that way. And I also highlighted that with that stock motor using 220v is to slow and 60hz creates a huming sound which hard to bare on a quiet day's. With that alone your opinion is out off the scope of my video. Next time try to understand the video objective. Thanks

[@dhansantv395]

Just to add something did you know that AC stands for alternating current And did you know that when I change the polarities of a DC continuously in a certain frequency that means I'm making THAT DC TO AC? So where were you on that part of the video? Before you said I didn't convert DC to AC?

[@davehunk855]

😱

[@aramixproduction4829]

Pwede ba kahit wala ng arduino

[@dhansantv395]

Pwede naman sir simple switching circuit with adjustable duty cycle pwede mas matipid lng arduino kasi pwede I adjust off time every pulse para mas efficient

[@aramixproduction4829]

Tutorial naman pappzz. Para sa mga begginer

[@dhansantv395]

@@aramixproduction4829 next time sir ill try to make it simplier

[@gabrielchristofoller1182]

Hi so

[@samikhandurrani1]

direct 12 better crant make a vedio

[@dhansantv395]

This type of motor is not capable of running on dc. Maybe swapping motor

[@wongmremojeporo7973]

Sui

[@matzkievalsur1770]

Ibalik mo ang mga cover kasi pangit kung wala

[@dhansantv395]

Less weight po at nag aaccumulate din po dun ang dust maam

[@argiemorta523]

Gunggong

[@dhansantv395]

🤦🤦🤦🤦

[@ronniebatulangacuma3315]

my ginawa.din akong ganyan kaso.umit agad my kulang pala