i have only been building mod motors for 4 years but this is the best assembly video i have ever seen. This is now my go to learning tool for all of my future builds. Thank you!
@2carpros11 ай бұрын
Wow, thanks!
@chriszermeno5279 Жыл бұрын
thanks for the vids, i hope you keep them coming was you finish
@outsidethelines2162 Жыл бұрын
So good!!!! ❤
@brandonparkinson5176 ай бұрын
Currently building my boss 260 and this guy’s videos have been amazing help!
@manderson68507 ай бұрын
Great video, but I have a question regarding ring placement. I'm using OE Ford Rings ( 6L3Z-6148-A). I can't tell which ring goes on top and which goes in the 2nd groove. There is a ring with green paint by the gap and the OD of the ring is dark/black in color. The other ring has yellow paint by the gap and the OD of the ring is a machined look to it. Both have a dimple/dot to indicate topside. Do you know if which ring I need to put in the top slot? Thanks and I enjoy watching your videos.
@garystocks85934 ай бұрын
THANK YOU
@stevewayne3676 Жыл бұрын
Is there a such thing as a rebuild kit that comes with everything youll need to rebuild? Sorry if thats a stupid question lol
@firepitfitness17411 ай бұрын
Inam thinking about swapping out my 4.6 3v out for a 5.4 3v but am wondering if the 5.4 3v rods and pistons are the same hp and torque rating?
@canalderegis10 ай бұрын
I have 15 and 16 clearance on my piston rings, is it too tight? Is it necessary to open them more? That's my question, thank you very much for your good videos.
@2carpros10 ай бұрын
Depends on the make. Refer to the manufactures spec that came with your rings. Thanks for watching!
@noahsaiz753610 ай бұрын
I have a question. I have dnj piston rings, the instructions state a 0.003-0.004 for every bore inch. My bore is 3.572 which is .010 to .014 ring gap. Should I go by this or go by your .018 and above ring gap?
@justinbuntin22026 ай бұрын
Any reason you went with king bearings on the rods and clevite on the mains?
@2carpros6 ай бұрын
The same King bearings for the rods were back ordered for 6 months and I didn't want to wait. The Clevite ones are really good too and are of the same tri metal blend as the King's. Thanks for watching!
@RickyRoberts-zw8nk5 ай бұрын
What cylinders fire at the same time as the number 8 cylinder
@wyattlove94504 ай бұрын
I install the Pistons but the crankshaft isn't moving I tighten the bolts like you did and everything
@2carpros4 ай бұрын
Then something isn't machined enough. Take it apart and plastigauge for tolerances. Thanks for watching!
@robertoudokrapf453 Жыл бұрын
OLÁ. Houve um ERRO de tradução. A palavra correta é "olhar bastante" e não "desperdiçar óleo". Nota-se que provavelmente nada aproveitarei de seu vídeo ABRAÇOS... Roberto Udo Krapf