3/4" Lightweight Concrete Panel Installation

[@thatguyBrettski]

Awesome concept, I bet it was a blast tos tans back and look at your first completed project. Well done guys on thinking it into existence

[@loafandjug321]

That wall looks great.

[@okra3000]

How much does that size panel cost?

[@Cherubinosangel]

How did you get the actual texture on the panel? Is it a mold stamp?

[@NSWvet83]

You should have your company link everywhere.

[@mor0gue]

Check for level after glueing and nailing...

[@adjrasta9365]

I thought same thing but this is just a basic how to video. Great product though

[@wondermom6458]

Is it ok to install it on a rough surface cement?

[@sopi2]

I love this. Do you ship to Europe, to Hungary?

[@tiborsaas]

Ahogy elnezem ezeket, lehet erdemesebb megcsinalni a paneleket DIY. Szarra aggodnam magam, hogy eltorik mire megkerkezik.

[@slavzurawski6123]

Why not make a mold and panels to size eliminating small pieces on perimeter??? oversize so the panel need to be cut on tp and sides to allow for uneven ceiling or floor etc, but visually the panel would look same size. One panel on bottom looks too white compared to others... looks add and draws the aye.

[@justinassirvidas1169]

This is not pvc yes? What its made of? Very good finished look of the wall :)

[@tunechii7]

where can i buy these?

[@tunechii7]

and can i do a ceiling with those?

[@AidynChalabayev]

Шифер белого цвета🙂

[@isa4777]

Hey Peeps, What thickness of plywood you recommend?

[@loafandjug321]

The minimum recommended thickness for structural panels used in wall sheathing is 5/16 inch for studs 16 inches on center and 3/8 inch for studs 24 inches on center. Rough side of osb facing out into the room for a stronger bond with construction adhesive.

[@germainwong]

This is such a poor install -- the corners don't even line up! This would drive me nuts!!!