3D PRINTED ROBOTIC ARM: JOINT 5 GEARBOX FINAL DESIGN!

[@metalheadmaker]

Nice work! I've been building a fully custom robotic arm on and off for a couple of years now. A lot of peoples' designs made the contact point of the motor an actual structural connection point, which is not ok. The joints should be able to operate using bearings without their motor in most situations, and then the motor can be introduced. At the very least, the motor should be mounted with supports like you have to minimize the radial load. It's awesome to see that you stumbled on this necessity as well!

[@kot2905]

Video good 👍

[@RichardRamos]

Great job

[@christophercalleja5329]

Really nice clean work well done enjoying watching these come together.

[@roboage1027]

Hey,nice to meet you here buddy! Thank you so much!

[@drivenba]

Great job, would love to see the testing continued to the point of part failure to see where the current weak point is!

[@vikavr5641]

Very!!!Very nice!!!

[@likefoodua1088]

Таку вагу піднімаєте 👍

[@williamhuang5329]

Hanzhen harmonic drive gear , strain wave reducer, robot joint , over 30 years experience

[@svitlana1367]

💪🇺🇦

[@benr3346]

Npc supporting the current thing!