3D Touch Probe - Cerca Bordi 3D elettronico - Setup e test run

[@MrHuntnfish]

Hi Andrea, Thank you for taking the time to tell us and review this 3D probe, YES I HAVE ORDERED MINE. shipping is 3-4 weeks. Regards Dave.

[@MecMod_Homeshop]

Hope you will be satisfied, I like and is precise

[@MecMod_Homeshop]

Thanks

[@MecMod_Homeshop]

I have to give one tip, replace immediately the three socket screw because are easy to wear, and you will not risk or go crazy, be gentle when you will set up with the screws because is easy to go out off.

[@MecMod_Homeshop]

4 socket screws not three 🙂

[@MrHuntnfish]

@@MecMod_Homeshop Yes I understand But I will contact you for advice when it arrives, stay safe my friend. Regards Dave.

[@MSM5500]

I always check a center position with a dial indicator after probing.

[@MecMod_Homeshop]

Top! Is always better 👍

[@markos3803]

nice video, thanks! does it make a beeping noise when it is activated or does it only light up red?

[@MecMod_Homeshop]

Hi, only red light, thanks for you kind comments

[@gianlucamacchia3683]

ciao, mi regalerebbero fresa molto simile alla tua, sono indeciso se tentare un restauro simile al tuo o cercare di convertirla a cnc, tu cosa mi cosigli? vale la pena?grazie

[@MecMod_Homeshop]

Bhe, e’ molto rigida, un blocco di macchina! Sai tu vai da manuale a cnc, due mondi differenti fra loro. Io se le guide non sono male cioè, tutto nella norma, la restaurerei se fossi in te. Poi decidi il da farsi se manuale, ibrida manuale come la mia o totalmente cnc. Avere qualcuno che te la regala e’ una gran cosa, se non la prendi tu dimmelo che me la vado a prendere io 🙂. Che testa ha questa fresa? Nel caso girami una foto, per curiosità, ciao

[@moto_miller7746]

Приветствую! Подскажите, какая резьба на игле? М3 или М4?

[@MecMod_Homeshop]

Sorry, where you are from? I can’t translate your words,

[@moto_miller7746]

@@MecMod_Homeshop I'm from Russia. I would like to know what thread is on the needle, m4 or m3? Thank you for the answer))

[@MecMod_Homeshop]

🙂, nice to ear that you are from Russia, what you mean for needle? You mean the thread pitch of my leads-crew?

[@moto_miller7746]

@@MecMod_Homeshop Yes, the thread pitch of the sensor, in the probe - device connection.

[@MecMod_Homeshop]

There isn’t any thread on the probe, you mean the 4?lateral screws for the fine adjustment? Are M3