4 Wheel Alignment on 2011 Infiniti EX35 Using Hunter Hawkeye Elite

[@TheGuruStud]

You can get aftermarket camber bolts that extend the adjustment a lot more. Subframe needs dremeled a little.

[@MintyFreshTurds]

Sometimes the subframe is already notched out just enough if you don't need to move it much. My Town Car only needed the bolts, no notching. Stock ride height ofcoarse.

[@tselishchev72]

I like that picture of the car on the print out. How can you do that?

[@kyleaholic2574]

There is a webcam that snaps a pic of the vehicle. It's a feature of the machine that the Hunter guys set up for us.

[@tselishchev72]

@@kyleaholic2574 thats nice. I did ask my installer bot nobody knows how to do it.

[@kyleaholic2574]

That's lame. If you have the same machine I have no doubt it can be done. I suppose it would be service mans fault that he doesn't know how... ours did.@@tselishchev72

[@tselishchev72]

Hi I got same Alignment machine. If i took one sensor Then haw re-compensate just one sensor. Tx.

[@kyleaholic2574]

Huh? Are you asking if you remove one sensor from the car do you have to recompensate just that one sensor? The answer is no, you need to recompensate the entire vehicle again. After you clip on the sensors they should not be moved or you have to start again.

[@tselishchev72]

@@kyleaholic2574 thank you for detail explanation . I use to work on DSP 700 old sensors , just bout new machine cannot reach my tech.