4jj1 engine fuel knock and low power

[@armansretunedgarage]

Thanks sa support mga Sir

[@rosesalinas2213]

Welcome boss arman

[@carloskarow7712]

Hello friend, how can I remove the injection pump? Do you have to remove the intake manifold first to get room? it is a 4jk1 engine any help is appreciated sir

[@armansretunedgarage]

You can remove the pump without removing the intake manifold. But if you want an easy access best Remove the intake manifold first

[@gtags84]

do u have to remove the pump to get to this?

[@armansretunedgarage]

No need to remove the pump just to access the fuel regulator.

[@Zigggy87]

Hi how come this was changed well this scv cause engine shaking on the 4jj1 can't read codes

[@armansretunedgarage]

Possible injector

[@marlonsarmiento4020]

idol may strainer ba ang ganyang pressurepump,,at san ho naka lagay

[@armansretunedgarage]

Meron din po

[@NelvardBatislaong]

Gud pm idol kailangan ba malakas ung bumba galing sa fuel tank,4jj1 2008 model

[@armansretunedgarage]

No need na malakas..

[@armansretunedgarage]

Bastat aabot lang sa engine . Ok na yon

[@xBTTAx]

Have you ever seen the high pressure fuel pump not push fuel through the common rail I have fuel going into the inlet to the high pressure pump and the return line is weak unless I force it through by pressurizing the gas tank I also tested that fuel solenoid you showed and it tested out at 2.3 ohMs And I’m still getting no fuel when it cranks .

[@armansretunedgarage]

Possible defective pump or fuel solenoid close.

[@armansretunedgarage]

Try not connecting voltage supply at the fuel solenoid so that the valve fully open And if still no output pressure Confirm high pressure pump defective

[@xBTTAx]

@@armansretunedgarage thank you boss

[@rosesalinas2213]

Boss gud day pwede mag tanong.naubusan Kasi ng krudo yong dmax 4jj1 engine.nilagyan n ng krudo ayaw na mag start

[@rosesalinas2213]

Nag bleed na Rin sa filter Ganon parin ayaw umandar

[@armansretunedgarage]

Anu vehicle year model?

[@armansretunedgarage]

Bleeding po

[@armansretunedgarage]

@@rosesalinas2213 If 2014 model Up... Pump lang ng pump po.

[@rosesalinas2213]

Boss gud day.2014 model wala n cxa hand pump nasa filter vent nua boss.nag palit nq fuel rail sensor ganon parin.dn fuel rail pressure nasa 170MPa.ang sa tingin q boss bala SCV.pero nalinisan q na rin yon boss arman.may cell number ka boss tawag aq.salamat sa mga sagot sa tanong q.Gob bless boss

[@norrisfredarapol5513]

pagkabit ng bagong scv sir..kailangan tlga e relearn ang unit.???

[@armansretunedgarage]

Kung sa CASA standard. Kailangan .

[@armansretunedgarage]

Kung walang specific SCANNER. Na pang relearn ok lang nman.

[@norrisfredarapol5513]

salamat po

[@amantikumera3496]

Nice 👍👍👍👍👍👍👍👍

[@roldandagatay1382]

Boss ok ba gamitin decarboniser

[@armansretunedgarage]

Ok rin naman pakunti kunti lang

[@biencarlomutya2665]

Sir pwd po mag ask san po banda ang fuel temperature sensor ng isuzu 4jj1 dmax boondock 2008?

[@armansretunedgarage]

Nasa high pressure pump.

[@ManuelAzarcon-ow7xg]

good day sir 4jj1 elf tanong lng po bigla nlng hihina minor niya meron nhuni bago humina. saka tatlo start bago umandar. ano po kya dahilan thanks po

[@AriesAcosta-g3o]

Sir ask ko lng po ganyan din pinalit ko sa dmax 2011 ko kaso nag fuel knocking at low power na ...anu yaka pwede pa gawin idol

[@armansretunedgarage]

@@AriesAcosta-g3o Pa check po. Kung Tamang parts ba and tamang installation

[@AriesAcosta-g3o]

@@armansretunedgarage genuine parts pa binili ko idol

[@armansretunedgarage]

@@AriesAcosta-g3o Baka iba po cause ng trouble

[@djzrex4081]

Sir innova 2006 po model pede po ba imodfied na ung scv nya." Kc maliit din po

[@armansretunedgarage]

Possible Pwede po.

[@diyexperience1911]

Asa dapit location nimu sir ? Thanks

[@armansretunedgarage]

Davao city po

[@diyexperience1911]

Napalit nako ni nga sakyanan sir sa davao kining naa sa imong vlog. Karon pako kablo na.ilisan na diay ni ug fuel supply ug scv. 😅

[@armansretunedgarage]

@@diyexperience1911 Maoba Sir. Gibaligya na diay ni na Unit?

[@diyexperience1911]

Ou sir, problema ko karon kay grabe vibration niya daun fuel knock. Nadaot diay duha ka injector hugaw kaayo. Basin naa kay surplus injector sa dmax sir.

[@armansretunedgarage]

@@diyexperience1911 Ayay. Wala hinoon koy injector pod Sir.

[@rjochoa3922]

Mg kano kuha mo sa pump boss

[@armansretunedgarage]

2nd hand 40k

[@rjochoa3922]

Wow sarap hina na kasi yung supply ng pump ng pick up ko dmax. O yung pump lang nya sa tangke may problema?

[@armansretunedgarage]

@@rjochoa3922 Possible sa high pressure pump

[@rustomgocotano2994]

Good evening Sir, ganito din sira sa papa ng dmax niya tapos pag mag aandar mamaya mamatay ulit tapos paandarin ulit matagal na mapa andar.

[@armansretunedgarage]

Mas magandang ma double check. Troubleshooting with SCAN tool.

[@toyvelardo9091]

sir gud pm..pp service Po sn alterra engine won't start , pag umandar pino nmn.ty

[@armansretunedgarage]

Yes Sir. Davao city po Ako

[@iamgoober]

very good sir :)

[@armansretunedgarage]

Thanks Sir

[@douglaslaruya5096]

Sir Armand meron bang specific SCV pra sa 4jj1?

[@armansretunedgarage]

Pag may problem na po ... Need palitan

[@khalidchoudry5757]

My same car P0651 P0000 P0193 P0231 can you splain what i do

[@khalidchoudry5757]

How to solve this issu

[@armansretunedgarage]

P0651- sensor reference voltage 2 circuit (Short or open) P0193 - fuel rail pressure sensor circuit high ( Short or grounded) P0231- fuel pump secondary circuit low - (Short or open circuit) Need engine electrical wiring harness diagnosis (line to line procedure) Check all these mentioned sensor ( tank fuel pump, fuel rail pressure sensor, EGR, Baro sensor, camshaft position sensor, fuel pump relay and also electronic control module)

[@armansretunedgarage]

Engine electrical wiring diagnosis -

[@marykriscabilin8586]

Bos anong sira izusu4jj1 napalitan ang sensor

[@armansretunedgarage]

Anu po concerned sa Unit?

[@jojoligsay3373]

Halo po ano kaya problema dmax 4jj1 nag palit po kami nang high presure pump surplus . Tapos Pina calibrate po Namin ung apat na injector nag palit na po kami nang scv ung andar na pro po pag naapakan mo rpm sa 1200 mag tik Rik sound po

[@jojoligsay3373]

Tik tik sound po ano kaya problema kasi Plano po sana Namin pa calibrate ulit sa manila denso

[@armansretunedgarage]

Possible nasa loob ng high pressure pump

[@titofranz3136]

Boss magkano kaya 4jj1 surplus engine ngayun?

[@armansretunedgarage]

100k cguro

[@domingodeleon5306]

sir arman may ginagawa ako 4hl1 pinalitan ko ng scv umandar tapos malayo na din tinakbo namatay uli pag tinatanggal ko yung socket ng scv umaandar sya wala nga lang accelator.possible kaya na fuel rai sensor?wala ako scanner ng 24volts.

[@armansretunedgarage]

Possible po... Pero mas magandang mas SCAN Para sure diagnosis tayo

[@domingodeleon5306]

@@armansretunedgaragesir arman magkano po kaya ang rail sensor 4hl1?

[@armansretunedgarage]

@@domingodeleon5306 Possible estimate price. 10k to 20k

[@domingodeleon5306]

@@armansretunedgarage salamat sir arman.

[@rmplchavez9229]

Boss nagpalit nko ng suction control valve tpos pag andar knocking pa din pag delete sa scanner bumalik sa ganda ung andar pero nabalik pa din ung dtc nya na P0091 parequest po ng video panu irelearn thanks sana mapansin

[@armansretunedgarage]

Nagpalit po ba fuel filter? And please double check SCV connection terminal

[@rosesalinas2213]

@@armansretunedgarage boss pano connection ng scv kc naubusan aq ng diesel.nakargahan n uli.nag bleed narin sa felter kaso ayaw parin umandar.pano kaya yon boss

[@armansretunedgarage]

@@rosesalinas2213 anu vehicle model po

[@armansretunedgarage]

@@rosesalinas2213 E bleed ng maigi bossing

[@armansretunedgarage]

2 wires lang po yon

[@fredielutao]

Paanu namn kung baba taas ang menor idol sak check engine.at bigla na mamatay at ayaw na mag start after 20 mins start ulit sya

[@armansretunedgarage]

Need scan diagnosis... Reading actual data

[@johnpaulvillareal6852]

Sir san nakaka bili niyan ng adaptor

[@armansretunedgarage]

Kasama napo sa set genuine modified Parts

[@MILLIONAIRE_CLUB908]

First

[@eliazardalma5322]

Pampalakas ba yan sa takbo

[@armansretunedgarage]

Hindi po. Pampa balik sa good running condition lang ng engine

[@biyaheradabawenya9088]

paano e check Kung sira Ang scv ?

[@armansretunedgarage]

1. Resistance check 2. Solenoid valve checking( 12volts supply) clicking sound 3. Check valve open and close

[@winnierevillame5783]

second 😃

[@escalde28]

san nabili boss scv long

[@armansretunedgarage]

Auto Parts Sir

[@armansretunedgarage]

Available rin sa ISUZU dealership

[@bismarkrimando7016]

😊