592xp Husqvarna 8 pin sprocket vs 7 pin sprocket

[@ScrewdriverTUNING]

Great comparison.!!!! Keep it up brother .!!!!

[@MitchellsBackyardLogging]

Thanks man have a good one

[@Aaron_A_Lynch]

Better to have the torque than speed..imo🤙🏻

[@MitchellsBackyardLogging]

Thats what i like for sure

[@clintdoucette2868]

Gotta give us the low down on the 562,looking at buying one in the near future. Great videos!!

[@MitchellsBackyardLogging]

You got it ill try to do one of all the 5 series together

[@MitchellsBackyardLogging]

Video should be coming out anytime of 562

[@clintdoucette2868]

Thank you sir! Looking forward to it!

[@ricktaylor3748]

@@MitchellsBackyardLogging Letting go of the handle is the quickest was of getting your hand \ arm \ face gashed with the running chain & bar. My 262 XP showed no mercy. I damn near lost my left hand, because I didn't keep my hand on the handle bar. I saw my hand dangling by veins. 46 stitches to repair my wrest and hand.

[@jdatwood7086]

I’m going to do the same to mine. Seems like it’s geared way too low for my use which is a 24” full comp or a 32” skip.

[@MitchellsBackyardLogging]

Good deal i like torq myself but it cuts good either way to me

[@jdatwood7086]

You got a part number for that?

[@MitchellsBackyardLogging]

@@jdatwood7086 i look when i get home if im not mistaken its the same one that fits other huskys like 390 372 i ran that 8 pin on them as well

[@MitchellsBackyardLogging]

@@jdatwood7086 i looked on the sprocket it just says 3/8 -8 on it in pretty sure the any large spline husky will fit it ive ran that same one on multiple saws

[@justinweaver8787]

Runs purdy good with both i do my cuttin on the dawgs so torque is my friend lol!!

[@MitchellsBackyardLogging]

Yea mine to i put the 7 pin back on her

[@JKSawShop]

You can’t be perfect even if you have a stopwatch out there.

[@MitchellsBackyardLogging]

No doubt

[@nicholasblohowiak29]

With more pins? Does that mean the faster the chain spins?

[@jdatwood7086]

Yes, higher gearing

[@nicholasblohowiak29]

@@jdatwood7086 I just bought a g660. What would an 8 pin do for it?

[@MitchellsBackyardLogging]

Yea it gives it more chain speed and to me it feels like its got a little less torq as far as an 8 pin for your 660 it depends on the wood your cutting and what you like torq or chainspeed

[@nicholasblohowiak29]

@@MitchellsBackyardLogging I’m usually cutting hardwoods. Maple, beech, ash and oak. And is it possible to get both?

[@MitchellsBackyardLogging]

@@nicholasblohowiak29 yea i got a set of 3 8 pin sprockets for 15 bucks or less im sure but honestly in hardwoods id stick to the 7 pin mostly people run 8 on ported saws