Before auto learn you have to set volts and wheel diameter before you auto learn again
@Dongskie25 күн бұрын
Where do I set the wheel diameter?
@FloridaVolts5 күн бұрын
Thanks I figured it out. New video tonight
@motormikemakropshop31372 күн бұрын
😅did you see if the motor is spinning backwards .?
@FloridaVolts2 күн бұрын
@@motormikemakropshop3137 😭 three weeks went by until I figured out. lol but yes. It was that as while as voltage setting. This is only a 500w motor not meant for this control. My 3kw motor arrives tomorrow. Sub for updated.
@motormikemakropshop313720 сағат бұрын
@FloridaVolts hey at least its figured out now yeabim subscribed
@RetroMods7 күн бұрын
That is a shame man, they do say you should remove chain so motor completely free when on auto learn. Hope you get sorted soon
@FloridaVolts7 күн бұрын
@@RetroMods that’s a good idea. I will try it
@knmanning12 сағат бұрын
Connect and disconnect the self-learning wire because your motor is geared so to make it cost so it has to learning wire or you can take the green and the blue in reverse them and then the motor be fine
@knmanning12 сағат бұрын
Reverse the green and blue wire
@TheYUNGBALLA884 күн бұрын
Your motor is done for bro sorry to break it to you
@FloridaVolts3 күн бұрын
😭😭 It’s still going but my NB Power 3kw arrives tomorrow. ⚡️⚡️
@EBIKEEDDIE08167 күн бұрын
Before auto learn u need to set volts and wheel diameter before u auto learn
@FloridaVolts7 күн бұрын
@@EBIKEEDDIE0816 thanks for advice. I went in and changed those!!!