87-91 Honda Prelude - (fixed) Distributor internal oil leaks repair

[@Prelude_88]

As far as I know, Prilyud 3 was installed by distributor Hitachi and TEC and they differ in design. Looks like a Hitachi in the video. Interesting. you can put Hitachi instead of TEC....

[@ChannelMAsk]

Not sure about this. But I’m my dizz is OEM.

[@andrewlee2344]

Nice!

[@blazeaglory]

It's weird I bought an aftermarket distributor off a3rd gen from the junk yard. Looks brand new but no matter what I do I can't get the shaft out! I've taken the OEM distributor apart a million times but this one the shaft won't budge and if I try to tap it out it looks like the bearing is starting to rip apart as well. Im stuck! It looks like the shaft is connected to the round metal part that is in the bearing because when the shaft spins so does that metal ring

[@ChannelMAsk]

The bearing and the shaft is 2 parts. Just break the bearing. It is good to replace a new bearing. But make sure the shaft is good. Otherwise, it’s better to buy another distributor.

[@Aileron90]

I think I ruined mine, key now won’t even fit in, and shaft doesn’t spin at all, jammed tight, idk why. Maybe I hit too hard when putting in??

[@ChannelMAsk]

Sorry I can’t tell you without seeing it.

[@DIGonzalez84]

what size O-Ring did you use at 9:41

[@DIGonzalez84]

was it the same size you used on you CYL Sensor?

[@ChannelMAsk]

@@DIGonzalez84 sorry I can’t remember, I replaced few months ago before I repair the distributor. I think it could be the same size as the Cyl sensor. Remember the O’ring is not for preventing oil leaks, it is for stopping the water to get in, same as the Cyl sensor. So, as long as the size fit with no gaps, then it is good enough. You can take the distributor to bearing shop to test the right size. That’s how I bought my O’rings~

[@willw4591]

@@DIGonzalez84 Did you ever figure out the size?

[@DIGonzalez84]

@@willw4591 never did. had other issues while working on this, and i had to buy a new distributor.

[@jasminelopez5803]

What part is that in front of where the distributer is?

[@ChannelMAsk]

CYL sensor. kzbin.info/www/bejne/oKqWe6inp7V5isU

[@blazeaglory]

where did u get the bearings?

[@ChannelMAsk]

6:42

[@blazeaglory]

@@ChannelMAsk Thanks. 12.5X32X10?? Also for the seal why not BH3888? I used it on my CYL SENSOR and it fit great. You can get the kit (seal + rubber O-ring) on ebay for $7.99 delivered

[@ChannelMAsk]

@@blazeaglory NOK BH38888-E. That’s the oil seal I used in the video. NOK - it’s the brand of oil seal.

[@DIGonzalez84]

@@ChannelMAsk what is the difference between NOK W0133-1640599 and NOK BH3888E

[@DIGonzalez84]

@@ChannelMAsk I would gladly pay you extra to purchase one of these bearings and ship it to the U.S... I can't find this bearing at any bearing shop or online.

[@udallfalcone3703]

pքɾօʍօʂʍ 😬

[@tremainher5167]

Do you have an Instagram or Facebook?

[@ChannelMAsk]

I don’t have instagram, no time to manage too much media. You can join Facebook group “Honda Prelude 3rd Gen Australia”. I’m in the group.