Fourth instalment in restoring my 1970 Morris Minor. Cleaning, painting and welding. Oh, and I set fire to the garage slightly...
Пікірлер: 12
@robpassfield10352 жыл бұрын
luck man!....you are making an excellent job there..
@doctormengele9612 жыл бұрын
Not embarrassing mate , your haveing a good go at it, it happens to all of us , had the same shit happen to me , was oxy welding rust on the rear quarter panel on a Morris Marina and the underseal caught on fire , frightens the shit out of you
@chrissandberg88562 жыл бұрын
GREAT work by the way, very challenging but your doing a great job. Been there done that myself. Something that you might try to help hold panels in place where the clamps don't quite fit is self tapping metal screws. Then when your tacked in place remove them and plug weld the small hole they leave behind. Might make for a better fit when your patching like you are. Something else that might save some time is the new replacement parts with the black finish is a good standard primer that car manufacturers use for replacement parts. You might save time and only remove what you need to weld it vs stripping the part completely only to reapply your primer. Just a suggestion but might help in your progress. Heat gun when scraping helps a lot. Just don't get it too hot..
@peterhansford5025 Жыл бұрын
Hello Mate, you are doing an excellent job and its making me remember of all the joy and fun that I've got to come putting new sills chassis legs and floors in mine this year. Never do any angle grinding or welding near your windows you'll put pits in them. Can't wait to see her finished and mine too! All the best.
@chucky2316 Жыл бұрын
It happend to me when welding my mazda up the underseal caught light. Luckily I smelt burning before it took hold lol
@adam1985ification Жыл бұрын
Hi mate Where did you get that floor edge panel 14.02 min of your video:)? Thanks
@hanvyj2 Жыл бұрын
All the panels I've been using are from esm www.morrisminorspares.com/
@samkelly4293 Жыл бұрын
Where are you getting the new replacement panels from.
@hanvyj2 Жыл бұрын
Andrew Eggleton: www.morrisminorspareparts.com/ Or ESM: www.morrisminorspares.com/
@malc45192 жыл бұрын
Hi what make is your welder
@hanvyj22 жыл бұрын
It's a Lincoln Bester 190C, pretty happy with it so far. Much prefer it to the Clarke EN151 I had before.
@roberthorseman7432 Жыл бұрын
I still have a Clarke near to 30 years old but still going.@@hanvyj2