A Quick Chat About an Issue I See in Shrouds…

Hey Guys! I wanted to pop in and share a common issue I see in shrouds when I am assembling them. It is a super quick fix if you catch it early, but will cause a headache if you don’t.
As noted in the video, I am filming alone here, so give me some grace with some of the clips! It’s hard to machine and film without chopping my hand or the shroud in half!
Here is the link to the products discussed in the video. When you buy through our Amazon storefront, it helps the channel so we can keep bringing this content to you.
www.amazon.com...

[@wvlongshooter3912]

I’m a sponge when Speedy talks. His knowledge is amazing!!! Thanks!!

[@johnhughes2043]

Once again, Speedy delivers a detail nugget with exceptional skill! The result IS the sum OF the details! Nice work Speedy, thanks.

[@RJMachine62]

Lots of times when the sharp edge is chamfered, it will raise a small burr on the I.D. I always chamfer from the inside out to prevent that.

[@jasonrad9332]

Thanks for sharing Speedy!

[@prone_wolf8871]

Thank you, Speedy! Hopefully, I can get a speedy built rig soon!

[@jennifermorgan6913]

love those old travadials😉

[@FClassJohn]

The Speedy is in the details...

[@jaybigboy34]

Love your videos Speedy!

[@1320pass]

Need to get me some micro 100's and some BoeLube now. Can't argue with that surface finish.

[@magic4221]

Must agree with Accu, would use a reamer rather than an interrupted cut with a boring bar.

[@AccuSol-ERN]

I think I would bore first to guarantee the hole is straight and cylindrical, then ream the remainder miniscule diameter. In my head, this would yield the same results (although added cost of non-standard reamer size) AND provide a better surface finish, especially if leaving in the white.

[@magic4221]

@AccuSol-ERN Very good point.

[@scottupatree3356]

I just use a small rat tail file 😅 kidding great information

[@IRONANDAMMO1988]

When you going to do a vid on blueprinting a fire control system ?

[@AccuSol-ERN]

I know it is tough with an interrupted cut, but what do you recommend for leaving a better surface finish inside the shroud where you did the single point boring? Maybe reaming the final .001 or .002? Do you find you open shrouds to the same diameter each time? Great video, it is always appreciated.

[@tonydevich7937]

Well when you take care of things they stay nice

[@take1one]

Can Cortina do this. Probably not. He'd probably need a computer gadget. Beep boop boy. Just kidding. Just commenting for the algorithm

[@mackellyman5642]

Excellent content, I'd film for you if I was around.

[@tonydevich7937]

Hello speedy