A Quick Comparison DU-BRO Prop Balancer V/S Magnetic Prop Balancer - Du-Bru 959 Replacement Shaft

[@wesjames6276]

Nice! In the market for a prop balancer right now- this has made my decision easy! Thanks!

[@oktrevor2010]

This is the prop balancer of choice for aeromodellers, had mine for twelve years , brilliant. Make sure you keep it in a bag, dust in the wheels acts as s brake over time. ✈️

[@barrywestfall6935]

YES!!!! Already have one from flying planes and helps!🤘🏼😎🤘🏼

[@roadstar499]

i have a large magnetic one i bought many years ago and works great.. mine is very simple but has a great design..

[@kareelrichards8824]

Thx for the quick response. Will give it a go.

[@Sweetaccord]

The magnetic will be WAY more sensitive to the balance of the prop with no friction. The Du-Bro have more friction and are not as accurate but will get you close. You have to be patient with the magnetic one. Spend the time to balance the shaft perfectly first. Add oil on the shaft also for less friction. Most won't care for a perfect balance just close enough. 😉 Tip: I add another magnet on one side outside the shaft to hold up larger props.

[@IRONCLADRC]

I need to order another magnetic Balancer my pins are short from trying to get them balanced. The next magnetic Balancer I get will be the etti magnetic prop balancer, not knocking the one I have it's like 7 years old and seen better days. Your definitely right about the du-bro not being as sensitive as a magnetic Balancer almost impossible to balance a props smaller than 32 mm..

[@adamjones9775]

I have ordered my first raw TFL-438 to balance, you have said a few times you like it for the BJ24. I was wondering, should CNC props be balanced or sharpened?

[@IRONCLADRC]

Cnc props usually come ready to go.. You'll like the tfl 438 especially if you've upgraded the esc & or motor.

[@rodneyrasmussen1199]

Quickest video yet , no coffee ect. Lol

[@IRONCLADRC]

Happy new year brother. Yep, no coffee on this one.

[@kareelrichards8824]

hey just a question when i try to balance a prop it goes straight across not where i could put it any position and it stays, so what am i doing wrong?

[@IRONCLADRC]

More than likely the hub is out of balance or an area close to the hub... when it's balancing horizontally what ever part of the prop thats under the center line needs attention (usually closer to the hub

[@jonathandemaria1865]

A lot of people knock this balancer they say its not for boat props,🤔. I use it with great results. No problem on my end

[@IRONCLADRC]

Yea so far so good I've balanced 3 props so far with out, Tearing the house down lol. Thanks again for watching