AAA Battery burner flame over 3,560˚ Fahrenheit! diy ideas you need in your life right now

Subscribe to Mr iPoo : bit.ly/3FrUgsT Become a channel sponsor and you will get access to exclusive bonuses. More details:
/ @mripoo
----------------------------------------------------------------------------------------
In this captivating video, we present to you the most amazing and useful life hacks that can significantly improve the quality of your life. Get ready for mind-blowing ideas that will make your everyday life simpler, more convenient, and more efficient.
----------------------------------------------------------------------------------------
TIMESTAMPS:
00:01 - Demonstrating how the AAA battery-powered gas torch works with a flame temperature of up to 3,560 degrees Fahrenheit.
00:05 - To make it, we need an old alkaline battery. Its casing should be made of thick metal; avoid using cheap ones, as they are often very thin and of low-quality metal.
00:20 - Drive the battery's positive contact inside to create a bowl. Be careful not to crack the metal or compromise the seal. I use a screwdriver attachment with a blunt end.
00:43 - Use a needle for inflating balls as a nozzle. Mark the needle at the side hole and also on the battery.
01:05 - Carefully cut around the battery casing with a pipe cutter aligned with the mark.
01:30 - Separate the cut part and clean the inside well, removing charcoal residue from the tube.
02:28 - Drill a hole in the center of the depression using a tool with a diameter equal to the needle.
02:39 - Around the needle hole, make 5-9 more holes within one to two millimeters. I use a sewing needle for this, gently piercing each hole. In a screwdriver, the needle acts like a drill, creating excellent holes in the metal.
03:20 - Cut a piece of copper tubing for air intake.
03:50 - Make a hole in the battery casing and weld the tube in place.
04:44 - For proper soldering, I use special acid.
05:29 - Cut the needle at the point where we made the mark earlier.
06:04 - Weld the needle tip to the battery casing. Only weld in a few places, as air should also be drawn through the copper ribs.
06:39 - The torch is ready; you can connect a valve for air supply and regulation. I use an aquarium pump for air supply.
07:00 - Connect the needle to the gas torch cylinder with a regulating valve. This is a safe design, as I use the original valve from the store, preventing any unpleasant incidents.
07:29 - Adjust the air supply, creating the perfect mixture.
08:05 - The torch is safe; it stays cool, and you can adjust the flame at any distance from the nozzle. Thus, the flame from the torch starts from 8 cm with proper adjustment.
This video is made for entertainment purposes. We do not make any warranties about the completeness, safety and reliability.The following video might feature activity performed by our actors within controlled environment - please use judgment, care, and precaution if you plan to replicate.
◉ TikTok: / mr.ipoo
◉ KZbin: / @mripoo
◉ Instagram: / mr_ipoo
Let's unleash your inner builder and craft amazing projects together. 🛠️

[@panchog2552]

Man you got more time on your hands than I do watching this.

[@markritchiejr4068]

I want torch good job 🎉

[@reshapinvapin5908]

Damn, i thought my drillbit boxset was complex and complete; now i need yours🤣 love all your creativity by the way, amazing stuff!!

[@TheZombieSaints]

More bullshit, butane does not burn that hot even with air assist. Waste oil burns waaaay hotter than this bs... 3500f indeed. 😂 What type of thermocouple did you use to measure that temp? There's very few that will go that high.

[@markritchiejr4068]

Can you made for me?