ABB Motor Water filled in Motor But was Running ok # only Bearing noise

installed new bearing SKF in motor because bearing noise more high
when we are open the motor found water in motor ,but motor was running ok and no short circuit ,

[@ahmedshaker343]

This is a very good example of how not to replace motor bearings ...

[@kazemmousa1]

😂😂😂

[@Hestherelaa]

🤣🤣🤣🤣🤣 whack them off! And wash with water

[@6047874]

New SKF roller bearing Made in Malaysia on the pack. Should have heated up the pulley before pushing it into the shaft, violent hammering not recommended.

[@hosseintaherimoghadam1175]

This can be done better with better tools. In addition, with the impact and improper tools, the sealing parts of the bearings are damaged and again cause premature damage.

[@hosseintaherimoghadam1175]

Thanks for sharing this video.good luck

[@swetagupta4843]

Siemens, ABB, CG ki motors best hoti h

[@mateuszdolasinski523]

OMG! :O At least it works...

[@hamcafaraceman8179]

اصلا عملکردتان خوب نبود بخصوص جا زدن بلبرینگ 😐😕

[@dbantendinamochannel6637]

Hasil mantap

[@sjaman9599]

Assalamu walaikum. Abb. 3phase.5hp.1425rpm.ki rewainding. Data plz dijie.

[@amedhossain6032]

very good job..

[@khanengineering4787]

V good....

[@trandung8109]

there are always have another better solution . Assembly bearing as yours way , sorry it not make pleasure to say : properly .

[@liaamelia2066]

Brutal.. No tracker

[@ahmedshaker343]

WHAT IN THE WORLD IS GOING ON HERE !

[@manoranjan4598]

Nice sir

[@juju-dd2bu]

what's this?

[@guillermoiturriaga7863]

🔥🔥🔥PRIMITIVE TECH💩💩💩 ISLAMIC TECH😂😂😂😂😂

[@vanhopcao1970]

Bad procedure....

[@swetagupta4843]

This is desi technique 😁