Accord CB7 | Vlog 53

Рет қаралды 1,041

Күн бұрын

Пікірлер: 15

@mrnajee1 3 жыл бұрын

Hey Moises, I saw your expose` on Automotive Anatomy nice piece. My set-up is very similar to yours except I did mines back in 08 when there wasn't much idea expansion on what we could use or couldn't for our CB platforms. I have a CB9 and did the 5lug conversion... back then most guys were doing the prelude set-up which turned out to be more complicated than it was worth. Owning an RA1, I knew that the chassis platform was the same as the wagon, so I went with the RA knuckles because like the wagon, it had bigger rotors than the coupes and sedans. I went what we called at the time, "the poor man's" big brake kit. It was the ACURA Legend GS front calibers which are dual-piston like the RL but instead of two small equal-sized pistons, the GS has one big piston and one small. Did the ITR rears like you as well...used a coupe rear trailing arm...remember I said I have a wagon lol! I just wanted to give you a little back story introduction but the main reason for reaching out is to find out what are you planning on replacing your SPC camber ball joints with as you did not mention in your interview, I curious to know what alternatives are out there. Thanks in advance for your response.

@Rival_Moii 3 жыл бұрын

Nice man! Thanks for watching that interview on his channel! I’m still using the SPC upper ball joint. I haven’t really done any other research other then knowing we can use the Skunk 2 EF upper control arm that is adjustable. I hear more cons about that then pros. Probably the reason I haven’t changed mine.

@mrnajee1 3 жыл бұрын

@@Rival_Moii One other thing, How do you loosen and tighten your SPC nut that sits on top of the A-frame? I cut out a massive hole in the top of my finder well to access through the top lol... probably not the best idea but it is hella easy to access during alignments.

@Rival_Moii 3 жыл бұрын

Well I have it maxed out for positive. So I don’t even touch it anymore unless I have to replace one. I wanted to cut my shock towers but I couldn’t pull the trigger on doing so. Lol.