ADXL345 with STM32 || I2C || OLED || CubeMx || Keil || HAL library

[@MehmetAliTurhan]

How can I find the libraries which you mentioned in the video?

[@sanketmodhe1267]

For this project what frequency i have to set for read or write?

[@ControllersTech]

For I2C ? You can set 400KHz. The sensor works fine with 100K - 400K.

[@cncryn35]

I constructed tihs circuit but i did not correct value, cause negative values is not correct ex: x values 65432 i need help thanks

[@ControllersTech]

+Dogancan Yuksel check your data type of x and compare it to the code u downloaded....

[@ArsenMikitov]

Спасибо тебе, добрый человек! Благодаря твоему видео я заставил работать STM32 и ADXL345! Super!!!

[@panuunap680]

mne tozhe nuzhen rezultat, ya ispolzuyu drugoy mikro_kontroller :)))

[@FlyHIGHSIM]

could you in the future show how to work with MAX17048 ?

[@woldecosgrove]

Hello i try duplicate this project on STM32H7, but was only able to show X, Y, Z all 0 values, could you please help?

[@Kixosxd]

i tried adxl345 through spi and i get only certain values that dont change at all...

[@canerboyraz9480]

I wonder why the values are high at some points where there is almost no acceleration. I mean when the values are close to 0 (breadboard on the table), I start moving the breadboard in different axes, and when I stop moving it, the values should show numbers close to 0 again, I suppose, but the values still stay high until the breadboard comes back to the starting position. thanks for your effort in these brilliant videos! you help a lot!

[@tg-xn6fi]

Thanks, really helpful for my work, while, I still wonder why here the adxl_address = 0x53

[@ControllersTech]

Unlike arduino, STM use the I2C address as (actual address + read/write bit), all together at once.

[@tg-xn6fi]

@@ControllersTech Thanks!!

[@rutvikmakwana2191]

sir how ADXL 345 Acceleration is step count with stm32 microcontroller please help me my project is OLED Based Fitness device

[@aminhosseini8573]

what is the name of your theme for windows 10 ? how ican install this theme ?

[@shaguntomar2947]

what is the meaning of "

[@ControllersTech]

Shifting the address by 1 bit to the left. 0x53 is 7 bit address as per the datasheet. STM32 HAL accespts 8 bit address, so we shift the adress to left by 1 bit.

[@mohitkumar-dz2hl]

I tried the library with stm32f0 but its giving error in library

[@ControllersTech]

What error exactly

[@vishalgyanchandani4437]

Can you make video based on pulse oximeter sensor with I2C & STM32

[@mekbots7607]

amazing ,could you please make video about adxl357?

[@aslanoymak6662]

superb, thanks for your work

[@manishrao8326]

It's good. But if you talk and explain it will be best.

[@aminhosseini8573]

thanks its good job

[@sergebattesti3166]

Thanks a lot.

[@cncryn35]

thanks for sharing

[@jaouadchafei]

Goood Job