Aerox Kurbelwelle einbauen 🔧 in 4 Min. / Scooter Yamaha Minarelli 50cc / 50ccm einbau

Kurbelwellen Einbau Minarelli
** Viel Spaß mit dem Video **

[@YandJMOTORSPORTS]

TOP

[@Farseer1995]

This is pure gold this is. Thanks mate for showing how to easily install the bearings and crank. I'll be off soon to buy a heat gun. One question, after this, the crankshaft doesn't need to be aligned or anything like that, right?

[@blackwhitestreetrox]

Thank you, I didn't have to align the crankshaft. If it turns hard you can give it a blow with a Rubber mallet and it will run perfectly again

[@RollerMobile79]

nice😃

[@kristianssurna1296]

Thank you

[@JeXYT]

Hey, how do you remoove all the moisture, after installing crank and bearings

[@lvga8935]

Great job! I have one question, what did you spray on the bearings before placing them in the engine block?

[@sil2659]

IT makes te bearings cold so he van put iT easy in the engine i rather not doing that because they van break sometimes

[@juliusju9145]

freezing aerosol or something like that

[@ivannovoselac3518]

Aren't original bearings with polyamide cage, not steel?

[@Phobu]

What rtv did you use ?

[@sir.bustanut1085]

Don't you need another oil seal on the other side? (side of the vario)

[@kp4643]

Yes you do

[@kayone8571]

Hi mate so I’ve got 70cc street race stage 6 I’m on standard crank it’s no good failed today what crank would you recommend

[@Kyrpis]

Doppler is good

[@kayone8571]

I’ve subscribed in case o need to do this

[@Xcdmdmdnd]

litteraly impossible, i have tried 3 bearings and just broke one crankshaft

[@markusjanson8336]

You just suck at it

[@SierzantYelonek]

3:00 Whats the torque? How many NM

[@camerongill8892]

i saw online that its 10-12Nm...someone correct me if im wrong

[@SierzantYelonek]

​@@camerongill8892 i already found 3 service manuals in which thay say 9Nm ... 11Nm is on four cylinder head bolts. Search for "Minarelli MA50 Engine Service Manual"