Affordable Glock Night Sights Installation With The VISM Rear Sight Pusher Tool

[@Advanceauto999]

Photography is good pictures are very clear

[@methodical_66]

You shouldve used some Loctite on the front site

[@Advanceauto999]

What did you use for video

I'm gonna go ahead and recommend getting some tritium sights for your weapon. If you're not going to use a red dot holographic sight, tritium would be your next best bet because they glow with or without exposure to light, on account of tritium being radioactive and all. Personally, I use a red color dot on my front sight and green dots on the rear. That way, in total darkness, I can tell the difference between my front sight and my rear sights. I just line them up green, red, green and I know I have a proper sight picture. I used to use all green, but I found that under pressure, I sometimes lined up my sight picture out of line with my intended Point of Impact. Using the red on the front resolved that issue for me. Great video.

[@YTsux24-7]

Thank you sir. Not a fan of most of the feyachi products I've seen so far but these look impressive. The vizm tool worked great!

[@NoblesTx]

That tool was a great addition to the tool box, can’t believe I haven’t bought one sooner to be honest!

[@tyjohnston5889]

I ordered one to take the factory rear sight off a Springfield XD Tactical .45. It stripped out the screw. Ordered another one as it was understandable and worked perfectly installing the replacement sights. My reasoning on why I re ordered: #1. No question as return policy #2. I put the quality as middle. Good for people with several guns of there own or some buddies and will come in handy again. Not heavy enough for gunsmiths. #3. I only ordered the first one AFTER breaking punches, drill bits, using lubricant, vices ect and end the end had to use my freaking dremmel to cut in half to sight removed

[@bobbyb7127]

Why the black gloves?

[@NRASUPPORTER1911]

What brand of sights did you use? I like the way they fit a lot of night sights they need to be filed down some yours fit good

[@antipeta3]

So do they have tritium in them? Or just glow paint

[@NoblesTx]

For 30$ just glow paint 😂

[@antipeta3]

@@NoblesTx still not to bad they look bright

[@trojansky2348]

You didn’t use the raising block to protect the bottom of your slide

[@bblauter]

Different sights but video worked great for me!

[@whitedime]

What size is that nut driver?

[@TheSRMproject]

Truglo tritiums night sights are only about $15 more bucks 😬

[@NoblesTx]

My poor is showing 😓 😂

[@alexzavala7372]

I bought a flashlight made by the same company

[@ncstar]

Great video! BTW: Instructions and how to video are available on our website. www.ncstar.com/optics-acc/tools/handgun-tools/vtuprs-univ-rear-sight-adjust-tool

[@NoblesTx]

Thanks! This sight pusher tool is a great addition to my tool bench! 👌