How to Wire a Race Car | Relay Fuse Panels - Part 1

[@hybridzdrift]

Just bought mine, 12 way with switches panel, Hard to beat!!

[@AirdoutRacing]

Will have it built/sent out soon!

[@MRE_Motorsports]

Getting ready to wire one of these up in my mustang !! Good stuff

[@andrewoglevie5401]

Just ordered a 6x6. Very clean set up.

[@supreme2544]

I would get my money back. Thats a horrible quality panel. Your asking for corroded wires and terminals.

[@matthewfenton8775]

@@supreme2544have you used one to know? Of the panels inside it shouldn’t Corrode surely?

[@khancross]

Instead of several relays which are ignitioned triggered, why not to add just one giant 200A relay and let this control an extra fuse box. This wiring will be ignition triggered and attached to this fuse box are components like power windows, headlights, turn signals, horn, radiator fan, fuel pump etc. Will this work?

[@weshanson7408]

Could you do a continuous solenoid instead of the 200A relay? Or why would you like pick one over the other?

[@vapate84]

do you happen to have a diagram showing how the flasher relay works with the main fuse panel?

[@KSwapTheWorld69]

I Am Planning On Doing This To My K Swapped 69 C10. It Is Know In My "K-Swap" Album.

[@octanemayhem2686]

Bro that is clean asf. I like how the inputs and outputs are on opposite sides. So basically you're bypassing things like immobilizer and 'main' relay.? Also if I'm deleting the dash/main harness for this setup what about the cluster ?

[@AirdoutRacing]

Yeah I completely rewired the whole car, not using cluster since the Holley comes with a screen. May upgrade to their large dash in the future

[@LJ-zz4so]

Getting ready to order this panel from you. What size wire is needed to power the relay board?

[@AirdoutRacing]

@@LJ-zz4so depends on panel, but the 12 way. Suggest 2-4 gauge

[@driftykamryn]

Hey man. Im currently in the middle of building a relay panel for my drift car. I am curious if I can wire a toggle switch in place of the "key" switch.

[@AirdoutRacing]

Yep! Can do that no problem

[@benvandeyssel4359]

Awesome work but if using a stand alone Holley system the power and ground go straight to the battery or you will have problems in the Holley instructions they will tell you many times.

[@AirdoutRacing]

Yes we always do that, just talking about wires to tell the Holley to turn on

[@coupecotv7985]

Question for ya boss man can this board be wired to the alternator charge wire or is it recommended strait to battery

[@AirdoutRacing]

Straight to battery!

[@coupecotv7985]

How many amps are the smaller relays

[@AirdoutRacing]

40amps

[@mitchellplatin5580]

This is great. But I didn’t see how the fuses were wired into the circuit.

[@AirdoutRacing]

Fuses are all in the middle under plastic over

[@Cody450sx]

Can I run this with stock ecu?

[@AirdoutRacing]

Yes!